chinny1266
New Member
- Posts
- 3
hi everyone need to pick you brains on a couple of maters i have with my p38 4.0 se
first iv had over heating problems,had gaskets done still reading hot so put new thermostat on still the same put new rad and temp sensors and still the same,took it for a drive and noticed that the two cooling fans were not cutting in how can i test them to see if they are working properley,iv run a live and earth to one ofthem and they work,
second the cowling around the instrument panel wont fit properley the holes are in the wrong place,at some stage it might have been changed would this affect the temp reading and why does it keep comming up with bonnet open,there is no wires on the catches so whys this happeng and how can i get rid of it
any ideas will be gratefull
first iv had over heating problems,had gaskets done still reading hot so put new thermostat on still the same put new rad and temp sensors and still the same,took it for a drive and noticed that the two cooling fans were not cutting in how can i test them to see if they are working properley,iv run a live and earth to one ofthem and they work,
second the cowling around the instrument panel wont fit properley the holes are in the wrong place,at some stage it might have been changed would this affect the temp reading and why does it keep comming up with bonnet open,there is no wires on the catches so whys this happeng and how can i get rid of it
any ideas will be gratefull
