Cold plating

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

The Mad Hat Man

Well-Known Member
LZIR Despatch Agent
Posts
83,235
Location
Embasinga stocæ
wot do yooz guys use to cold galvanise yo motors after cleaning back to bare metal?

I have dde-rusted back to good metal, but want to plate the metal prior to priming and repainting.
 
I cant see wot red oxide (Lead) has over Zinc products. They both use the sacrificial anode? principle to protect the steel and a both heavy metal based paints.

Have you tried that stuff, Trewy and is it good?

Wot product did you use, DV?

Galvafroid
Rustoleum

or just Hammerite?
 
once i replated it, i is gonna respray the areas and then underbody Schultz it. - It wont rot again fur a week or two.

It may seem like overkill, but bear in mind I only use it for offroading, so it gets a lot of mud and muck forced in everywhere - I know - i had to remove it.

The headlights and front indicators had an inch of mud INSIDE them and the underwing areas were caked thick with Salisbury muck.
 
Another one that I've used for years is Bonda Rust Primer + Zinc.
It's a resin based zinc and rust coating.
 
Back
Top