stokie
Member
- Posts
- 16
- Location
- Newcastle under Lyme
Whilst swapping my clutch slave cylinder because it went spongey . As i pulled the cylinder off the bell housing the pushrod and clip came with it .
Has any body got any tips to refit it while the engine is still in the truck
I have tried a tube over the pushrod to act as a sleeve that will push the clip
I have even driled and tapped a hole in the bellhousing to push the clutch arm forward so i could press against it .
The last resort is engine out for the sake of a 50p clip ......Any ideas
Has any body got any tips to refit it while the engine is still in the truck
I have tried a tube over the pushrod to act as a sleeve that will push the clip
I have even driled and tapped a hole in the bellhousing to push the clutch arm forward so i could press against it .
The last resort is engine out for the sake of a 50p clip ......Any ideas
