Clutch bleed - elecrical box removal, LHD

On my LHD Freelander 2004 TD4, in order to get at my clutch master cylinder I need to remove the L-shaped plastic box containing the ECU etc., which restricts access, to say the least. But how do I get it off ?! I can see one side is a sort of clip, but levering that with a screwdriver doesn't free the whole box. I'm sure it's the same as RHD (which has easier access to clutch cylinder), so how is it held in? Thanks R

Shouldnt need to....Shove your arm down and pull the rubber cap off the master cylinder, then top up the fluid using a wee funnel and a bit of tubing. Its a bit of a fiddle the first time, but easier than faffing about trying to shift the boxes.

Yep, but on LHD (left hand drive) it is really tucked away in the corner of the bulkhead. If I could remove that L-shaped box it would be 10 times easier.

I know fine well where it is on LHD versions - Mine is LHD and needs to be bled once every couple of months due to a small air leak - that is what I was talking about.

OK ! Sorry for assuming you were on RHD, just Looks like horrendous struggle to get in there. Did you ever change cylinder or just Keep topping up? What were the symptoms - pedal frees clutch at bottom of travel or sinking pedal. Thanks R

The bite point gets lower and lower until it will not select first or reverse with the engine running. A quick bleed gets it going as normal again for a couple of months.
I have a replacement master cylinder, I just need to be bothered fitting it.