Chrome swivel balls

Y

yardo

New Member

Posts

19

• Nov 7, 2010

• #1

I thinks mine have had it very corroded, I was wondering if anyone has had them re chromed, or isn't it worth it. Has anyone tried any ways of refurbing them.

 

M

mikebeetle

New Member

Posts

143

Location

Leicestershire

• Nov 7, 2010

• #2

I looked into it recently. You can get them rechromed and polished for about £70 the pair. Problem is you then would need to get the holes for the bearings and railko machined out.
Best to look for some decent second hand ones, not sure about the quality of aftermarket ones though

 

R

roach

New Member

Posts

10

• Nov 7, 2010

• #3

if it just surface rust then just rub it down an fill the housing with one shot grease but if they are pitted badly start looking for new ones.

 

V8jon

Well-Known Member

Posts

1,439

Location

Pembrokeshire west Wales

• Nov 7, 2010

• #4

Years ago a mate of mine used to rub them down and then varnish them where the seal runs,don't know if it would work cos I never tried it. Personaly if it's ****ing oil out I would be fitting new ones

 

Y

yardo

New Member

Posts

19

• Nov 7, 2010

• #5

Thanks for replies, I suppose its a case of is the corrosion going to damage the seals or new seals on a refurb. Re chroming doesn't seem worth it I like the idea of varnishing and could perhaps see that working.

 

B

b20wnx

Well-Known Member

Posts

1,077

Location

wakefield west yorkshire

• Jun 23, 2011

• #6

yardo said:

Thanks for replies, I suppose its a case of is the corrosion going to damage the seals or new seals on a refurb. Re chroming doesn't seem worth it I like the idea of varnishing and could perhaps see that working.

Click to expand...

yardo - what did you do in the end, i have same problem but thinking of going down the new route but expensive and there dont seem to be any used one for sale without rest of axle....

 

tottot

Well-Known Member

Posts

8,073

Location

west wales coast

• Jun 24, 2011

• #7

Remove any rust lumps and fill pits with epoxy resin,run seal over ball to smooth out before resin sets.Use the 5 min stuff, lasted a couple of years on my old series 2.

 

B

b20wnx

Well-Known Member

Posts

1,077

Location

wakefield west yorkshire

• Jun 24, 2011

• #8

tottot said:

Remove any rust lumps and fill pits with epoxy resin,run seal over ball to smooth out before resin sets.Use the 5 min stuff, lasted a couple of years on my old series 2.

Click to expand...

thanks mate - will give that a go.