Changing anti roll bar links

Hi

As part of getting my freelanders work done for the MOT I have had to change the anti roll bar links, managed to get it off after much shouting and bad language! Anyway think I have a made a newbie error, the roll bar link is connected to the roll bar, and I need to know how to push it back down to get it into the hole to screw it up!! Any help most appreciated

Thanks

I think I remember bolting the bottom link to roll bar then using a crow bar on roll bar to help pop the top in ?

You need to lift the whole front. If the opposite wheel is on the ground the bar will try to replicate that at the lifted side. This will make the bar difficult to fit.

Nodge68 said:

You need to lift the whole front. If the opposite wheel is on the ground the bar will try to equalise the side in the air.

Click to expand...

Thanks, will try tomorrow

Nodge68 said:

You need to lift the whole front. If the opposite wheel is on the ground the bar will try to replicate that at the lifted side. This will make the bar difficult to fit.

Click to expand...

Thanks for that, should have realised when I did the job, anyway all done one