cb radio

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

saxokid18

New Member
Posts
516
Location
barnsley
hi got a cb fitted to my landy digital with a swr meter and speaker and huge ariel
the thing is i havent a clue how to use it and not sure if its set up correctly
is there any 1 localy to burton on trent willing to come a check it over or i will go etc as i cannot find any cb places about
i can turn it on etc search it finds nothing and keeps going through and can only hear very little noise through the speaker the cb is maycom
thanks
 
did you make sure you joined the coax rite,the inner has to be seperate to outer,as one part recieves the signal,the other transmits,if any part of the two meet it wont work right,just something for you to check,all the best,nunny
 
did you make sure you joined the coax rite,the inner has to be seperate to outer,as one part recieves the signal,the other transmits,if any part of the two meet it wont work right,just something for you to check,all the best,nunny


Errm no the outer cable acts as as an earth point and shields the inner core thus preventing interference form external soources and ensures the signal reaches the antenna as clean as possible. In effect it is a faraday cage
 
when i installed mine i seperated the cable and connected the oter part to ground and the inner to ariel.so guess your right,a lad thats been into cb,s years told me what i wrote in the above,but thinking bowt it ya right,apologies
 
hi got a cb fitted to my landy digital with a swr meter and speaker and huge ariel
the thing is i havent a clue how to use it and not sure if its set up correctly
is there any 1 localy to burton on trent willing to come a check it over or i will go etc as i cannot find any cb places about
i can turn it on etc search it finds nothing and keeps going through and can only hear very little noise through the speaker the cb is maycom
thanks

there is not that many 'breakers' on anymore, if it's one of them, new digital ones, are you in the right mode, most people still use 27mhz (uk 40) and some use the higher part of the band CEPT/Mid block (European) band, depends if you have set either the uk 40, or the european band in when you turned it on, or the CB you have may gives you the 80 channels back to back, you'll have to state which radio you have.

Also there could be nobody in range, i can get to a home based antenna 17 miles away from the CB in the car, but he only picks me up because he has quite a good radio, and antenna, my range from my homebased antenna to my car is about 3-4 miles, so depending if anybody else is tranmitting in your catch area, then you'll hear nothing, try asking for a radio check on channel 19 uk 40 band, see if anybody responds.

hope this helps :)
 
Last edited:
So, without wishing to take over post. Any ideas about a CB that works ok with engine off but when on, gets really poor reception, ta
 
Came already with cable in dash from previous owner. Picking up on MHM comment, got replacement alternator a few months back so could be related. Any other views appreciated as is ****ing me off now
 
Just a question...when you said digital, i hope you meant a digital display?

The new digital two ways require licences, they run on the same frequency as taxis/emergency services etc - to run one privately would cost £200 licence fee. These will have a good dozen or so numbered buttons on, so enable you to direct call a frequency. Similar to the old scanners.

Analogue CB's either digital display or otherwise will cost nothing as the old frequency is no longer used.
 
Back
Top