Bulkhead Welder

Hi,

Have read that you need minimum of 130 amps to weld Land Rovers.

This seems high to me, it would be fine if you want to weld the chassis.
But i just want to weld in some new footwells, so im thinking even 100amps would be enough, as the bulkhead is a lot thinner.

Do you think ill be ok with 105 amp Mig, i only want it for this job then ill sell it on, so instead of spending loads, It will cost much less.

Any help/idea/thoughts on this?

Thanks,

Biosbill

Get an experienced welder to weld it and then you won't need to worry about amps, buying and selling a welder, and how to fill in the bloody big holes you blasted in the steel because (like me) you aren't much of a welder!

CharlesY

dont even need that much, turn it down a bit more.