L322 Bottom ball joint
- Thread starter Wazzajnr
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
biketeacherdave
Well-Known Member
- Posts
- 4,892
- Location
- south east london
No remove the whole hub trust me it's much easier
myfirstl322
Well-Known Member
- Posts
- 41,354
- Location
- Hoots mon...
LR I believe have a slide hammer type extractor.
When I did mine I used a combination of slim chisels and a large punch and sledge hammer on the top, taking care around the CV boot of course.
- Posts
- 16,479
I battered mine like I was jacking off to hardcore porn....after a few moments it finally relented and fell out!
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Oh Ant! You've just admitted you only last a few moments, mind you its enough to fill a pram.
- Posts
- 16,479
....twice....Oh Ant! You've just admitted you only last a few moments, mind you its enough to fill a pram.
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
One side finished, just need to find a socket to fit the drive shaft nut so I can take the hub off to do the other side. I'll also get some new cv gaitors and might do wheel bearings whilst it's in bits. It'll have to wait a week or two though now.
Willos
Active Member
- Posts
- 521
- Location
- Huntingdon Cambs
36mm 12 point socket if i remember
Thanks, I'll try and find one before I do the drivers side.
