Disco 2 Borrow a part, ACE, pressure transducer?

Before I buy a new one, does anyone have a spare or unusd pressure transducer I can try to make sure it is definately that?

When I get back, if my old block is where I left it I'll give you a message.

Jamiegreen said:

When I get back, if my old block is where I left it I'll give you a message.

Click to expand...

Thanks

You still after the part mate? I got the block so could get it off and send it to you if you want.

Jamiegreen said:

You still after the part mate? I got the block so could get it off and send it to you if you want.

Click to expand...

PM sent (hopefully)

Oh well time to buy a deep drive 27mm socket as last time I fitted a pressure sensor was after rebuilding so sittting on a piece of card behind the car (me and valve block).

By then should be warm enough I hope

Got the socket, drizzle and temperature has dropped a lot.

Will have to watch the weather when I have a good half hour of warm and dry

I just pulled the pipes out the spare to get a spanner on there when I realised I didn't have a deep 27mm, tried to swap my wheels today till the high speed winds and snow came and put a stop to it, plus this disco has ..23mm nuts.. thinking they must be imperial.

Still not working, suspect presure is actually low.

One last test is going to be to measure pressure when unplugged in case problem in loom.

Have you tested it with Hawkeye? Any codes, will it perform the ACE test?
But quite simply beyond the basic plumbing of it I'm not too knowledgeable on the whole system, I've got other parts if you need to try anything else though.

Jamiegreen said:

Have you tested it with Hawkeye? Any codes, will it perform the ACE test?
But quite simply beyond the basic plumbing of it I'm not too knowledgeable on the whole system, I've got other parts if you need to try anything else though.

Click to expand...

yes no no