bollix to balls

baggyjim · Aug 10, 2008

hi just spent a very frustrating day sorting me balls, putting it all back together and have a problem as when i do up the stub axle flange the drive shaft goes tight and wont turn, got landrover parts manual every thing in right order is it another case of ****part as it came as kit from paddocks

boydy1989 · Aug 10, 2008

How tight are the wheel bearings?

I did this job on my LR the other day, but i left the drive flange and bearings all alone, ill post a guide if its gonna be any use.

Check the drive flange is in line and aint trying to bent the CV in a funny way or summat

baggyjim · Aug 10, 2008

not got as far as putting hub back so bearings not issue seems like the shaft is being clamped tight as difficult to swivel the hub as well wondering if its prob with ****part black ball

boydy1989 · Aug 10, 2008

Can't see how it could be. What bit are you tightening up to make it go tight?

baggyjim · Aug 10, 2008

the stub axle onto the swivel pin housing ie ball fixed to axle swivel housing onto ball slide shaft in ok bolt on stubaxle with mudshield all goes tight

baggyjim · Aug 10, 2008

ffs just read other manual i got landrover workshop manual hadnt seated drive member in bush in flange properly all sorted ta:
even me doris thinks im a plank so feel free to have a laff as well

bollix to balls

baggyjim

New Member

boydy1989

Well-Known Member

baggyjim

New Member

boydy1989

Well-Known Member

baggyjim

New Member

baggyjim

New Member

Similar threads