Brilliant ! KYG101190 M10X92 flange head bolt looks exactly what I need. Clicking on the other parts and getting the drop down menu, I could not find the ANR5258 bolt only the ANR5258. Was that just a slip of the finger on the keyboard ? Anyway I need x4 of the bolts to go through the body mounts outriggers front and rear.
it was a typo error i meant ANR5257
The front ones are accessable through the front floor footwell. The other ones don`t seem to be that are located by rear passenger footwell, unless I missed them ? It does seem strange if there is no access to the back ones, when there is to the front. Also why did Land rover make a perfect v shaped trap for mud/dirt between the rear seat body & the wheel arch ? Surely it would of made sence to move this rearwards & allow easier access to the bolts.
Except the ones for the rear outrigger - which I fear is the one the OP is on about
That is the one. It is level with where the rear door closes. I was thinking of putting it in upside too, or cutting an access channel & welding it back up again. I just don`t see why they did not make access to it easy when there is the room to do so. I don`t really want to cut it though and was unsure wether putting the bolt in upside down would cause any issues ? I was just thinking it has to be done the hard way by lifting the body.Except the ones for the rear outrigger - which I fear is the one the OP is on about
I ended up grinding the bolt off until it was short enough to come out of the space between outrigger and body - and then put the new one on the other way up - with the nut in the space
I think that they did this because you can put a small bolt in from above when you are using the hexagonal extension for the step - and they either didn't realise or (more likely) care that it would be impossible to undo 15 years later!! I have both rear outrigger bolts reversed and they have caused no problems so far, and the mot tester had no issues with them either.
I think that they did this because you can put a small bolt in from above when you are using the hexagonal extension for the step - and they either didn't realise or (more likely) care that it would be impossible to undo 15 years later!! I have both rear outrigger bolts reversed and they have caused no problems so far, and the mot tester had no issues with them either.
Welcome To LandyZone, the Land Rover Forums!
Here at LandyZone we have plenty of very knowledgable members so if you have any questions about your Land Rover or just want to connect with other Landy owners, you're in the right place.
Registering is free and easy just click here, we hope to see you on the forums soon!
