Anyone got diagnostics to clear EAS fault?
- Thread starter jacko33
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
holidaychicken
Well-Known Member
- Posts
- 4,014
- Location
- Kent
what vehicle ?
holidaychicken
Well-Known Member
- Posts
- 4,014
- Location
- Kent
Ok, sorry, i only got an allcomms for the l322, i am in fareham on wednesday that was all but no use to you
I've actually got the software & the cable to do everything but I can't load it up on my laptop,tried loads of times but to no avail! If you used my software & lead would you be able to help me at all please? I'll happily give you a drink for helping me out
- Posts
- 18,999
- Location
- Buckinghamshire, UK. ('95 DT)
Yeah got lead & software of Datatek back in 2013
- Posts
- 18,999
- Location
- Buckinghamshire, UK. ('95 DT)
Does your laptop have a serial port or are you using a USB converter?
holidaychicken
Well-Known Member
- Posts
- 4,014
- Location
- Kent
I don't have a clue about the P38 or the software so I don't think i would be any use to you
- Posts
- 83,232
- Location
- Embasinga stocæ
- Posts
- 58,170
- Location
- Preston Lancs.
It MUST be a Windows laptop. It MUST have Net frame work loaded. If you are using a serial to USB adaptor. You MUST load the USB adaptor software driver BEFORE you plug the USB adaptor into the laptop. Or Windows will load a generic driver that does not work with your particular adaptor. You may have to change com ports to find the loaded driver to get it to work. Default com port does not always work. Sometimes they can be a pin in the arse. Someone with a Nanocom could do it in a couple of minutes.
Hi Wammers, i've just posted another thread within the "Range Rover" section again with pictures of what is comoing up when I try to upload
