Another idiots guide needed please

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Pootz

Active Member
Posts
115
Location
Birmingham, West Midlands
I've got holes in my bumper that I was informed are for headlight washer jets...How do these wire up in simple term please or can I just run a pipe from the windscreen washer jets with a T piece.
I'd rather have them there instead of holes
Cheers
 
I've got holes in my bumper that I was informed are for headlight washer jets...How do these wire up in simple term please or can I just run a pipe from the windscreen washer jets with a T piece.
I'd rather have them there instead of holes
Cheers
Just put blanking grommets in the holes.
 
My first thoughts were that if you T in to the windscreen water pipe you might get a bit of drain back, through the various branches, which will cause a delay when you try to wash your screen. If you decide to do that you can get one way valves to go in the water pipes to stop back flow.
Are you sure the holes aren't off spot lights the previous owner had on?
 
My first thoughts were that if you T in to the windscreen water pipe you might get a bit of drain back, through the various branches, which will cause a delay when you try to wash your screen. If you decide to that that you can get one way valves to go in the water pipes to stop back flow.
Are you sure the holes aren't off spot lights the previous owner had on?
Definitely not off spotlights as they're directly under the center of the headlights in the bumper.
Spotlights there would block the headlights.
Can't think of anything else it would be apart from washers
 
Definitely not off spotlights as they're directly under the center of the headlights in the bumper.
Spotlights there would block the headlights.
Can't think of anything else it would be apart from washers
Yeah, sounds like washer jets, then.
 
Back
Top