angular torque gauge

andrewblueboy · Mar 4, 2010

hi all

im doing me head gasket tomorrow so been out and bought the tool,now theres no instructions and ive done a search on infor on how to use the thing.so point is anyone know how to use this cheers andy

andrewblueboy · Mar 4, 2010

the tool is the round dial type for measuring degrees but not sure how u set it up, ive normally torque wrenche but its the degree im stuck on any infor appreacited andy

martinhollings · Mar 4, 2010

every corner of the bolt head is 60* so mark the the head and the sockett the only thing you need to work out is the 20* i guess this and mark the sockett (just less than half a corner)

vivnap · Mar 4, 2010

there is an L shaped 'rod' you can adjust on the dial gauge. put this 'rod' against something solid and set the dial gauge to 0 degrees. simply turn the torque gauge to the required degrees

they might look a bit complicated but they are really easy to use

andrewblueboy · Mar 5, 2010

cheers

,now i understand,sounds so simple when explained, well suppose i better get on with the job then

angular torque gauge

andrewblueboy

Active Member

andrewblueboy

Active Member

martinhollings

New Member

vivnap

Banned

andrewblueboy

Active Member

Similar threads