Disco 2 ACE issue any ideas
- Thread starter MJI
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Jamiegreen
Well-Known Member
- Posts
- 628
- Location
- Wales
Fluid still high and will check under bonnet fuse tomorrow, cabin fuses OK
Been sat in a workshop for 3 days and they thoguht it was on all the time.
But the -1.43G points to something cable or electrical
sierrafery
Well-Known Member
- Posts
- 17,103
- Location
- Arad/Romania
Was the vehicle on level ground with all the doors closed?
sierrafery
Well-Known Member
- Posts
- 17,103
- Location
- Arad/Romania
What kind of tester was used? anything else than Hawkeye, Lynx or Tesbook is not reliable with ACE... did you drive it before you read the fault code? , if not read again after a drive and if still no code while the warning is on the ACE ECU becomes suspect
Jamiegreen
Well-Known Member
- Posts
- 628
- Location
- Wales
If it came down to the ACE ECU, I have a spare you could have, but would probably need to post as your a good 3 hours away.
Well... if I could get the damn thing out, that top bolt...
Well... if I could get the damn thing out, that top bolt...
My Hawkeye finally, no fault codes, appears to be no power to something.
sierrafery
Well-Known Member
- Posts
- 17,103
- Location
- Arad/Romania
Check fuse F15 engine bay and if it's good swap relays R14 - R13 and try the horns and if you dont get the horn sound tghen it means R14 was fubar and you need a new one
If it came down to the ACE ECU, I have a spare you could have, but would probably need to post as your a good 3 hours away.
Well... if I could get the damn thing out, that top bolt...
May have to it seems thanks
sierrafery
Well-Known Member
- Posts
- 17,103
- Location
- Arad/Romania
Go with hawkeye to Actuators and test the relay, you should hear it clicking on test
No clicking heard and also would not stay in the option and kept going back to menu.
sierrafery
Well-Known Member
- Posts
- 17,103
- Location
- Arad/Romania
Are'nt you doing something wrong there?
Not as far as I know, I went into the option, and if I did not press quick enough onm the tick it came back to menu
sierrafery
Well-Known Member
- Posts
- 17,103
- Location
- Arad/Romania
See RAVE - Electrical library - connector views - C0017 and make sure it's not corrosion in it, insist on pins 5 - 6
Will do, bit wet now so tomorrow
Jamiegreen
Well-Known Member
- Posts
- 628
- Location
- Wales
