ABS problems

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Freediscoranger

Freediscoranger

Active Member
Posts
744
Location
Cirencester/ west shropshire
Hay all, I have a 94 300tdi es manual. Last week I changed a swivel and both front wheel bearings, before then it every now and then had the ABS Light stay on when driving but normally cured my turning it off and on. But today the light came on while I was driving and now it won't go away :( i know the ABS sensor is on the top swivel pin but I have no idea how it worked (but my mechanic friend put it on for me) so just wondering what I could've done to cause this/ what I can try and do about it. Preferably with minimal help from the garage (save the pennies)
Thanks for the help!
 
cv has castleated ring around it that sends pulse every time castlation passes sensor end if gap isnt right it interupts signal giving fault signal from ecu gap can vary due to not pushed in far enough and held properly in pin ,swivel brgs not adjusted let housing move ,cv not pulled through enough and shimmed with circlip ,cv where it runs in stub axle worn/damaged,wiring to sensor damaged
 
i dont know from here whever its tight or loose just giving some ideas,of things that could effect abs after you working on your truck obviously it could just be coincidence
 
Yeah I understand, it's very hard to diagnose a car over the Internet :L but thanks for all the advise and I'll see what I can do, if not it's going in for a pre MOT with a friend so I'll get him to diagnose. Thanks again James :)
 
You must log in or register to reply here.

Similar threads

I
TD5 Map and ABS error
Replies
1
Views
419
sierrafery
sierrafery
C
Disco td5 abs light
Replies
5
Views
1K
Anaconda
A
D
ABS Light
Replies
1
Views
496
Anaconda
A
Badger688
Disco 2 ABS Modulator Replacement
Replies
7
Views
687
Anaconda
A
H
2001 td5 disco alternator problems???
2
Replies
27
Views
1K
Stanleysteamer
Stanleysteamer
Back
Top