P38A ABS and TC lights on

Radar1946 · Oct 18, 2020

Hi All, I have just fitted new brake discs, new calipers, new brake pipes and new sensors. I have bleed the brakes the best I could. No air in any of the brake calipers. No fault codes but the ABS and TC lights stay on and I have a message saying traction fault. I have read some of the other answers on here but none seem to be the problem.

kermit_rr · Oct 18, 2020

Which sensors did you replace? Is your battery healthy and fully charged?

Radar1946 · Oct 18, 2020

All four wheel speed sensors. Battery is fully charged

kermit_rr · Oct 18, 2020

Were they damaged? Could a new one be duff? Double check they are all pressed full home, no dirt or rust in the way etc

Radar1946 · Oct 18, 2020

They are all brand new, and my lynks diagnostic says no faults. I will go and check they are fully home.

Radar1946 · Oct 18, 2020

Tried diagnostics again and it came up this time with right front sensor fault. So I did as you suggested and went round them all and tapped them with a small rubber mallet.
As by magic all works fine now. Thanks.

P38A ABS and TC lights on

Radar1946

Active Member

kermit_rr

Very

Radar1946

Active Member

kermit_rr

Very

Radar1946

Active Member

Radar1946

Active Member

Similar threads