Series 3 4 way brake pipe union

Hi. A quick question about this manky thing. I'm getting to the point where I need to refit it (I have cleaned it up but don't have a picture handy). Does it matter where the pipes connect? I know how they came off so can reconnect the same way but I could run the pipes neater if I change things. There aren't any valves in this thing so I can't see a problem. Could someone with actual knowledge confirm. Thanks. Steve.

As you say it is just a union so can be piped any way you want to.

Outstanding! Thanks @Blackburn for the confirmation.

That bolt goes to a bracket on the chassis.roughly under the master cylinder. Trial fit it to work out the best way round, I seem to recall it fits 2 ways. I'm assuming you have single circuit brakes otherwise you need a 3 way. The line from the master goes to the top, the front goes to off-side front, the bottom goes down then back across the crossmember to the near side front, the rear goes along the top of the chassis to a flexy to a T on the axle.

Thanks for that. Mine was a real mess. Pipes not clipped on properly, cable ties everywhere and the part of the chassis where the 4 way bolts to had rotted away completely. I'm making it up as I go with this.

I seem to recall it ca go on te top of the chassis or the inside face, its much easier to pipe up on the side. Get loads of these as 1/2 will break when you fit them:
https://www.ebay.co.uk/itm/25161151...MIt4yDoJOu9AIVRgKLCh2hGQieEAQYASABEgKrEvD_BwE

To be honest i've gone for rubber lined p clips. The originality boat has sailed on this land rover
https://www.ebay.co.uk/itm/28178567...KTb0XLKVBw%3D%3D|clp:2334524|tkp:BFBM2JaOzKlf

I have a mix of both, works fine.