4.0 oil leak p38

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

lowfat

Active Member
Posts
427
Location
Cornishwall
Ok so had the motor a couple of years . Seems its had an oil leak from new. never leaves a drip on the floor but from the oil filter back its wet. the steering arm is covered .

can't make out if it's the oil cooler pipes. Is there a usual suspect?
 
I've had the oil light switch leak out from the terminal, started fairly low level but got worse over a few weeks.

Thought it was the sealing washer, but it was the switch itself.

Early single-terminal switches are replaced by a twin-terminal unit, and a small adapter wire is available to use existing wiring.

I got a new switch from a motor factors that was single terminal.

Peter
 
I've had the oil light switch leak out from the terminal, started fairly low level but got worse over a few weeks.

Thought it was the sealing washer, but it was the switch itself.

Early single-terminal switches are replaced by a twin-terminal unit, and a small adapter wire is available to use existing wiring.

I got a new switch from a motor factors that was single terminal.

Peter
+1 That's where the leak came from when my switch went bad. It had a pinhole in it and it was amazing how much oil it spewed from such a tiny hole. To get home from work, I pulled the switch and cleaned it up with acetone then epoxied the hole. That fix lasted long enough to get a new one.
 
Here's the old one on top and the new type:

DiscoTimingCov.jpg


Peter
 
Back
Top