Jack300tray
Member
- Posts
- 42
- Location
- Evasham
Hi all, I'm in the process of wiring up a switch panel. Can anyone tell what the 5 wires on the back of the barrel are for. Thanks
300tdi ignition barrel wires!
- Thread starter Jack300tray
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
sierrafery
Well-Known Member
- Posts
- 18,282
- Location
- Arad/Romania
Hi, that's quite a vague question, what do you mean by "what the wires are for"? ... obviously they are all lives distributed through the switch from the main feed which is the brown wire coming from maxi fuse MF5 engine compartment, the others are going to the fascia fusebox where are splitted toward various circuits as follows:
-green/white to accessory relay
-white/red to F17
-white to F15,16,18
-yellow to F1, 13, 14 and sattelite fusebox F3, 4, 5
to your question i can't answer anything else, if you want to know something specific ask the right question saying exactly what are you after and i'll try to help
-green/white to accessory relay
-white/red to F17
-white to F15,16,18
-yellow to F1, 13, 14 and sattelite fusebox F3, 4, 5
to your question i can't answer anything else, if you want to know something specific ask the right question saying exactly what are you after and i'll try to help
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
Hi @Jack300tray
I would suggest looking at a wiring diagram is your best bet, if you do not have a haynes to hand then try downloading the Rave workshop file onto a computer
Cheers
I would suggest looking at a wiring diagram is your best bet, if you do not have a haynes to hand then try downloading the Rave workshop file onto a computer
Cheers
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
sierrafery
Well-Known Member
- Posts
- 18,282
- Location
- Arad/Romania
That diagram was already translated in english at post #2 
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
That diagram was already translated in english at post #2
The court is out on that..........LOL
Cheers
Jack300tray
Member
- Posts
- 42
- Location
- Evasham
Thank you, has made it a lot clearer
what it done is put a switch panel in with a push start, just wanted to know what went were Thanks
discool
Well-Known Member
- Posts
- 13,719
Thank you, has made it a lot clearer
Thanks
So u have installed a press non-latching switch in series with the white/red wire to the starter, instead of turning the to the starting position.
