2 issues. How to get stub axle nut off and vibration

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
W

Willos

Active Member
Posts
521
Location
Huntingdon Cambs
Firstly im trying to replace the cv gaitor on my p38 but stubbled at the first hurdle.
I cannot move the nut off the stub axle end. My 600mm braker bar with a extention over it wont budge it. #A mate came round last night and shattered his britool breaker bar :doh:. Any ideas on this one.

Secondly im getting a vibration from the engine at 3000 revs in drive but also in neutral stationary, so im thinking engine mounts . Is this correct ?:confused:

Thanks
 
First of all knock back the stake on the nut then use a 3/4" socket set to remove the nut. Many 1/2" breaker bars are not up to the job unless you have a Stahlwille or Snap-on one. Steady pressure on the bar, NO snatching on it. And turn it the correct way of course.
 
You must log in or register to reply here.
Back
Top