P38A Back again, Newbie P38

[Irishss]

00, P38, M51, 2.5 Oil Burner.

Hello again,
Back for more assistance.

Ok, solved the non-long start issue…in tank pump replacement and she fires instantly.

Next to tackle wayward steering….I replaced a track rod end and will need tracking.
What steering damper is recommended????
Is Brit part a no no?

Then the vent blowers….i did replace the pollen filters and air..
Photo included …unbelievable
Air con is not working..Dont really need it..Irish weather.
Getting the book symbol..

Is there a manual way to direct the vent to the windscreen-demist..
I’m happy with just a demister..

I will test relays today and fuses…

Again new to the Range Rover..thanks.

 

[Datatek]

00, P38, M51, 2.5 Oil Burner.

Hello again,
Back for more assistance.

Ok, solved the non-long start issue…in tank pump replacement and she fires instantly.

Next to tackle wayward steering….I replaced a track rod end and will need tracking.
What steering damper is recommended????
Is Brit part a no no?

Then the vent blowers….i did replace the pollen filters and air..
Photo included …unbelievable
Air con is not working..Dont really need it..Irish weather.
Getting the book symbol..

Is there a manual way to direct the vent to the windscreen-demist..
I’m happy with just a demister..

I will test relays today and fuses…

Again new to the Range Rover..thanks.

The book symbol is due to failure of the blend motors not the aircon. Access the blend motors, remove the one for the blend flap and then position the flap manually.
Anything but Brtipart for the steering damper. Take the old one off and test it first or you may be wasting your money. Drag link ends, the other end of the track rod or swivels may be the cause of your steering problems.

 

[Mark Piercy]

Even the terrafirma steering damper leaks... Get an original and you'll never need another.
Those filters are in a poor state... Jeez

 

[Irishss]

Update, was testing the 2 rel

The book symbol is due to failure of the blend motors not the aircon. Access the blend motors, remove the one for the blend flap and then position the flap manually.
Anything but Brtipart for the steering damper. Take the old one off and test it first or you may be wasting your money. Drag link ends, the other end of the track rod or swivels may be the cause of your steering problems.

Is it a dash out ..to access blend motor

 

[Datatek]

Update, was testing the 2 rel

Is it a dash out ..to access blend motor

No. Panels under steering wheel and glove box, plus side panels to transmission tunnel. Easier on RHD than LHD

 

[brianp38dse]

Wandering steering can be the radius are bushes, they should sit in the center of the axle mount if you can move them sideways with a bar they are shot.

 

[marjon]

Wandering steering can also be the joint halfway down the steering column, if all other joints seem fine.

J