- Posts
- 31,618
- Location
- North Shropshire
Yes, not til i get home, don't want to tempt fate! Maybe lunch time tomorrow depending on the weather
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 18,982
- Location
- Buckinghamshire, UK. ('95 DT)
Usually just get loud in the cab!
Know what you mean, it's bloody freezing here got a job to do on my car but, waiting for parts, so no rush and, it might warm up
a bit at the weekend.
- Posts
- 31,618
- Location
- North Shropshire
Bugger. Just had the belt tensioner and idler pulley replaced.. something is squeaking again.. sounds driver's side but can't pin point it. Suppose I'm going to have to take the belt off and give things a poke
- Posts
- 5,741
- Location
- North Manchester
Just fitted a new plastic gear to my replacement BMW E46 rear wiper motor and installed on the L322, £65 total cost 
Scotiawhiskers
Well-Known Member
- Posts
- 842
- Location
- Manchester
My Ford one just a bit of judder on sharp take off, and a bit of an odd squeal with gentle clutch use. And went on like that for thousands of miles no issue. Came on slowly too, not in 50 miles.
Loose bolt(s) or breakup of something like a crank damper?
badfluffy
Well-Known Member
- Posts
- 1,667
- Location
- northampton
all judder goes if i dip the clutch pedal whilst moving thats why i thought of flywheel
Scotiawhiskers
Well-Known Member
- Posts
- 842
- Location
- Manchester
From some Google reverse image searching and text searching, it looks like a Trackstar tracker. So I think you should have got a fob with it. Or the subscription has expired and it shouldn't actually do anything.any clues on this one? theres a black box with an orange flashing light, underneath the rear fuse box
big warning sticker on the front saying to connect the internal battery before commissioning and to remove the label afterwards.. obviously that wasn't done, but the LED implies its 'commissioned' and working
is it something to do with trailer lights? should it be flashing orange? or does that mean its broked? orange/red usually means bad
View attachment 283946
https://www.ebay.co.uk/itm/284029655459
Scotiawhiskers
Well-Known Member
- Posts
- 842
- Location
- Manchester
Loose / broken engine / gearbox mount, only reacting under load?
- Posts
- 31,618
- Location
- North Shropshire
Wow, you're a star! Thank you! Yes that looks exactly like it. I didn't get any fobs other than 2 car keys and the remote heat thingy.
I do need to un plumb it though, it's pulling power all the time
- Posts
- 31,618
- Location
- North Shropshire
- Posts
- 31,618
- Location
- North Shropshire
It must have heard i wanted to get it dirty so it's trying to find an excuse
Still not given it/them a name.. don't really want to fall back to 'bastid'
- Posts
- 31,618
- Location
- North Shropshire
Just been looking at how you replace an idle pulley on the 4.4tdv8!! Blimey you've got to take half the car to bits!!!!
- Posts
- 12,190
- Location
- Sud ouest France !
I'd go through the engine mounts as suggest and check the props for play
badfluffy
Well-Known Member
- Posts
- 1,667
- Location
- northampton
props were the first thing i checked, im wondering if its engine as i had just filled up from a supermarket filling stationI'd go through the engine mounts as suggest and check the props for play
- Posts
- 31,618
- Location
- North Shropshire
if the fuel was bad, would affect lots of people, these engines will run fine on any grade fuel you put in them
- Posts
- 18,982
- Location
- Buckinghamshire, UK. ('95 DT)
The dual mass flywheel is like 2 circles, front and back but with springs inside. The springs get tired over time and then don't absorb the clatter coming down the crank. Once under load the springs are compressed so it shouldn't make much difference other than the vibration coming down it.
I'd be checking mounts for judder, as above.
Datatek
Well-Known Member
- Posts
- 44,072
- Location
- Near Poitiers SW France
Springs? Never seen one with springs, the two parts are usually bonded to rubber like a crank damper.
- Posts
- 31,618
- Location
- North Shropshire
think bmw uses springs
- Posts
- 31,618
- Location
- North Shropshire
just been reading up on electronic dipsticks.. seems the 4.4tdv8 has a process..
with bonnet open, ignition on, press cruise cancel twice to enter service mode, this shows the *actual* level.. top up as necessary.. press and hold the cancel button for more than 5 seconds then close the bonnet and turn off ignition to exit service mode. screen now shows an 'average' oil level
is this right? or just for certain cars with this engine? pressing cancel appears to do bugger all for me
with bonnet open, ignition on, press cruise cancel twice to enter service mode, this shows the *actual* level.. top up as necessary.. press and hold the cancel button for more than 5 seconds then close the bonnet and turn off ignition to exit service mode. screen now shows an 'average' oil level
is this right? or just for certain cars with this engine? pressing cancel appears to do bugger all for me
