Immobiliser problems

[DANSARCAL]

The drivers door lock has too much play in it, car has gone on lockdown cannot put in EKA code as door lock has too much play so do not know what i can do, does anyone have any ideas as my Rangy will not start and is blocking the drive
Please help a desperate woman in need

 

[fanatic]

Rick the pick

 

[wammers]

The drivers door lock has too much play in it, car has gone on lockdown cannot put in EKA code as door lock has too much play so do not know what i can do, does anyone have any ideas as my Rangy will not start and is blocking the drive
Please help a desperate woman in need

Repair the lock and take the play out or find someone with a Nanocom to put the EKA in for you or disable it for the time being. Do you have keycode lockout message? That comes by entering wrong code to many times. Wait until it goes off (about half an hour to an hour) then when entering EKA code do it twice only then open and close drivers door, for two more tries. Keep doing that and you will never get keycode lockout message. If you say where you are someone may help.

 

[mozz smith]

wammers you chattin young ladies up again ???? you'll be sending em cake next !!!!!! hope your both well n ok mate ,,

regards mozz .

 

[Grrrrrr]

The drivers door lock has too much play in it, car has gone on lockdown cannot put in EKA code as door lock has too much play so do not know what i can do, does anyone have any ideas as my Rangy will not start and is blocking the drive
Please help a desperate woman in need

If you take the door-card off you can activate the microswitches on the bottom of the lock actuator to enter the EKA code but as Wammers said, easier to just stop the lock moving.

 

[Grrrrrr]

If you put your location in there might be someone nearby who could help.

 

[wammers]

wammers you chattin young ladies up again ???? you'll be sending em cake next !!!!!! hope your both well n ok mate ,,

regards mozz .

Hiya Mozz all good here.

 

[Rick-the-Pick]

You can enter the EKA code with the drivers door open, place left hand on internal up/down latch, & right hand turning the key in the door.
As you lock the car, push internal latch down fully, & when you turn the key to the open position, pull the internal latch up fully.
This should help you get full movement of lock mechanism.

 

[brianp38dse]

That's a handy tip Rick will have to log that for future reference