What have you done to your Landie today.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Used it (with the big Ifor Williams trailer) to collect a gert big kitchen range that the Doris bought.

Just got to build the kitchen to fit it in now! :doh:
 
Begged, borrowed and (mostly) stole some wood to hopefully get a little more done to kitting out the back ready for the LZ10 weekend.

Painted everything in the cab higher than the windscreen (except me hat) 'stone white'.....ok ok beige :rolleyes:....but didn't take any pics so it didn't happen. Looks a lot nicer though :D
 
just jet washed my disco today, blasted the outside more to get the seagull ****e off more than anything, but washed the coating of sand all under the bonnet areas = living next to a beach does have downsides.....
must do list still is,
change steering damper,
change oil light switch,
hum and har over whether to put my new (now getting old in its box) alternator on,
but my lazy head says leave the existing one well alone till its broke..
oh, and while I`m under my old disco, see if I can use a rusty but tough towbar I`ve just found for a front mounted tow ball ;)
 
tinted the rear screen and the rear side windows just wondering if the alpine windows should be done then tried to sort the lack of power to the boot light only to get the lights doing their own thing so gave up at that and will try again at some point
 
Stuck some cheap nylon carpet on the floor and wheel well sides in the rear, hopefully it'll stop the tools and chequer plate from rattling.

Fully charged the battery. Tidied up some bits and found a throttle cable that don't look too happy, but it'll do for now after a little fettle. It's no wonder it felt like it was hanging back a little, it just wasn't being given a chance.

Tried to fit a flap to the rear door to make a folding table, ran out of bloody pop rivets .. annoyed!

Gonna take out the centre seat today, I think and try to fit a bucket seat for my side, the back has 'lost' it's foam a bit ..
 
Intending on oil change (the lot) and a service.
Including removing all me brake pads, sanding em off, cleaning up the calipers n putting it all back together, cos the squeal annoying me now...
Oh, and the rear ARB links, cos the clunkings annoying me too.
 
Done bits to it, but then went and helped tc do man stuff and used his V8 ...

DSC_0001_zpsb63f0e3f.jpg


DSC_0002_zps486cef84.jpg


Brought wood, steel and 'stuff to build stuff with' ...

A roof will be made first though ... sometime tomorrow .. ;)
 
wired my roof bar lights up so they now run in three relays off of an auxilery fuse box in the engine bay instead of the one relay and one 30 amp fuse that they used to run for about 30 seconds before blowing the fuse now they run properly :D
 
Back
Top