Search results

hello people still not resolved the high reving prob scanner says throttle position sensor but had three on there..has anyone had prob with one under diesel pump?? drive normal then car looses power then engine light comes on,touch throttle and car then goes again. at idle car revs then settles...

Oops it's a 4.0 v8

Hello guys I'm about to tackle the removal of the sump Trouble is there is lots of bolts and nuts To make my job abit easier how many do I undo Leaking sump gasget is the cause!! Thank you Eddie

Hello all the heater on my p38 blows out heat as temperture says on passenger side but on drivers side its just cold even when set to high:lalala: any ideas Eddie

Hello guys After goin over a speed bump last week the abs and traction light come on. When I take keys out ignition the traction warning message illuminates . And when I start car same message comes up then when I drive the abs fault comes up Any ideas Gunna disconnect all wheel sensors but...

my eas is going up and down on its own so if i get a cable and plug in to my laptop can i just see faults or fix the problem??

disconnected rf receiver but becm still has power any other ideas cheers

thanks datatek will get another loom

great feed back guys...is that standard about replacing engines at 100k ive spoke to colman milne who modified it but not yet ive any info going through the to do list!! having to replace everything on the inside due to some naughty scallywags who have been on their way to a police cell its...

hello guys now as i got the wrong harness supplied i am in need of a small amount of power to move the seats..does anyone know if i can put a feed to the seat just to move it for now untill i get the correct loom think i got a hse loom as i have a plug left over on each seat please help as ive...

mine seams to go up and down ok but now and then you hear eas making noises when driving maybe a split hose! good luck tho

hello after trying to find out info on my ex police rangy ive stumbled across a label on the speedo reading rs notts i understand that they are calibrated by rs not sure on who or where as ive googled them but no real answers anyone out there with an ex police rangy would like to find out alot...

cheers speedyyellow but what and where is the RF Receiver thx Eddie

mine is going dead after a week too got a fuse tester to see if any current going through circuits but all is fine I have noticed though that the bcem under seat is making a faint noise.. will try changing alternator cheers

hello all ive bought a twin seat loom but when wiring up ive a plug left over on both seats! green to seat blue to bcom 2xwhite one to car and i have a large one left over any ideas on this cheers

Hello everyone Please can someone help with an airbag light on Mot failure only on this only!! Phew... I have a code 9008 drivers airbag...seat or steering wheel... Also 9040/36928 Any help would be much appreciated Eddie

Datatek is that someone on here or a company??? cheers

I have just worked out why my air bag light is on!! my vehicle is 2002 and its been fitted with non air bag seats...grrrr does anyone know how i can write the seats out of the ecu. i know someone out there can do it...its just finding them thank you Eddie

great help guys thank you eddie

Cheers for reply Just had it a week,was ex police so had no manuals etc Is this op only for overhaul when removing Thx again