Search results

Hi, On ebay now item number: 321741339319 Good lock

hi, Have you reset the base idle speed, I had a similar problem with a disco a few years ago and the very nice and helpful Bruce at Camco88 (Warrington)advised that I should check and reset the base idle speed (BIS), he went on to explain that if the BIS is incorrect then the engine management...

HI, where in Derbyshire are you? Regards Phil

Hi, upgrade to a later Bosch starter (permanent magnet, reduction gear) it will make huge difference, I have a 2.5NAD fitted with a starter from a 300tdi auto and it starts quite well, a vast improvement on the old style starter which melted both cables and battery when it failed, mine will...

Hi, yes it is similar to the one retro fitted to the 2.5NAD (ERR2886, thanks for the part number JM) which is what I will probably end up using. I already have a sump with the return welded in from my old engine 2.5NAD. the cyclone fitted to the 200 and 300 tdi is also a possible, however one of...

Hi, I am looking for the pert number for the cyclone breather that was fitted by land rover to the very last 19j's, See photo attached. The breather/ cyclone is just to the left of the fuel lift pump, my good friends at Lr, speke spent an age looking through old parts catalogues and even...

Hi. Google Duckworth Landrover and give them a ring, I got a set of half leather puma seats complete with runners for £500 inc delivery and they are so much nicer than most retrims..

Have you considered a receiver hitch front and rear and a winch tray ti suit, then you only have to carry it when you really need it

Hi, I think the were £54 but that included everything to fit them, even the little 'O' rings to stop water tracking along the bolt through the door, I think they do a set for the 4 dr too. Rather than just ordering from their website I would give them a ring, al the guys are very helpful and...

Hi, I treated my 90 to a set of the heavy duty Britpart covers ( the ones with the Umbrella in the Corner), they are very good, more of a canvas type really and at £60 for the fronts, much cheaper than the Exmore canvas covers. they fit really well and so far haven't suffered sweaty bum...

Hi, I have Britpart discs all round on my 90, Solids on front, with Delphi pads on the front and the Britpart pads on the rear, and after nearly 15000 miles thay are still working perfectly, with no abnormal wear on ay disc, regards

Hi, yes the pictures do show the tensile strength, that's what the 3 lines are.... its American or Japanese. if you do use aftermarket bolts make sure that the Shoulder (Un treaded Portion) is of sufficient length) and f you opt for the 10.9 (High clamping force) that you use nuts and washers...

HI, what loom are you looking for? I have a late 200 tdi/ early 300 tdi bulkhead loom, otherwise Autosparks are great, I would get the latest spec loom possible, they tend to use more relays so don't burn switches etc, phil

? why change if already on discs??

I had a similar problem, the inner gutter was filling with water but only when parked on the level, I fortunately have access to a former landrover techie who advised running some q bond into the joints on the patchwork quilt of a roof and by jove it worked....Phil

I had a similar problem, the inner gutter was filling with water but only when parked on the level, I fortunately have access to a former landrover techie who advised running some q bond into the joints on the patchwork quilt of a roof and by jove it worked....Phil

Hi, I would fit the new calipers, the cheap ones I fitted to the rear of my 90 have been fine, I was going to fit new seals but when I stripped the caliper the pistons were pitted and the bore was corroded at the dust shield fitting point.. I would advise washing the bearings out, checking them...

Hi, I fitted Puma seats into my '87 90 without any problems as replacements for some TD5 seats that had broken, I think all I had to do was drill out the mounting points in the seat box to 8mm and put thick spacer washers between the seatbox and runner, you have to do this to allow room for the...

Hi, Got mine (Later style) as a 2 door set from LR in Liverpool came complete with door shims, a-post gaskets, New style passivated bolts, everything you need to fit them and am really pleased with the quality, far better than the £7 items I see all the time on ebay..., Phil

Hi My 90 made a knocking which was felt throughout the vehicle and after a day of checking we tracked the source to the steering box itself, we adjusted the box as per instructions in the manual and the clunk went away for a few weeks but came back this weekend so recon box time I think. regards