Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. C

    Hybrid. Help identifying sticky locks, worn barrels so i can replace.

    I have had a look about and think these are from a later defender. I want to change barrels in the door handles. Struggling to pinpoint which ones they are. Can anyone confirm what age or barrel I should be buying from the photos. Help much appreciated.
  2. C

    Hybrid defender body to range rover 91 chassis lower steering column to steering box.

    Looking to sort out a missing part, the one shown is too short. Are the splines the same on other landrovers that I can get a new replacment? Identify what this is off would be a start.
  3. C

    Range Rover 1990 Transfer Case Viscous Coupling Seized

    I have a 1990 3.9 EFI with ZF4HP and a borg warner transfer box under my series 2 landy. I am pretty sure the transfer box viscous coupling is seized. I am going to test tomorrow. I have noise when off throttle slowing. Ie wheels are make the drive train turn and not the engine. It seems to...
  4. C

    3.9 efi no fuel, wont start, tested injectors right bank 8 ohms.........

    I have 3.9 EFI range rover in a 90. It turns over, sparks, but wont inject fuel. The fuel pump spins. Not checked pressure yet as it seems to move fuel. It just stopped whilst idling a while ago, now won't fuel. Gone though the Haynes manual efi checks. Everything's good until the injector...
  5. C

    Range rover 4.2 Supercharged Head Gasket or Crack?

    I reckon I have a combustion gas leaking into the coolant. Coolant was slowly dissapearing and there are small bubbles in the expansion tank. This is a right pain, job I can do. But didn't need it now. What are the chances of this being a cracked head or block? Anyone heard off blocks heads...
  6. C

    Range Rover Supercharged 2007 wiring diagram heated cooled seats dead

    Hi All, Heated and cooled seats are now dead on my 07 RRSC. Anyone had similar problem. I am presuming a fuse has blown somewhere as the drivers seat has not heated properly for a while. So now none of the controls go blue or red when turning the controls.....
  7. C

    Suspension fault c1a55-01

    Well had my first suspension fault. 2007 Range Rover Supercharged However it is. c1a55-01 air suspension ignition switch input circuit. Bings up a few seconds after starting, but air suspension works fine, confusing . Changing my autobox cooler lines and all the belts and pulleys tomorrow...
  8. C

    2007 SC Spare Key fob

    I have been trying to sort out a complete spare key for my 2007 Supercharged Range Rover with part success. Local autolocksmith has sorted a spare that will manually open the door and start by copying my current keys transponder. Tried 3 locksmith diagnostics tools to try and program a spare key...
  9. C

    DR650SE for sale 1999

    Sold Hi All Got my DR650SE for sale on the Bay. Suzuki DR650SE DR650 Enduro Supermoto | eBay I want 1500 ovno Also Got Lathe and KDX for sale Cheers Chris
  10. C

    1995 4.6 MOT LPG until 18th october spares or repair lost drive?

    Advertising for a person who can't use a computer! Here is another one that might end up on in the breakers yard. !Engine and gearbox need work! It has working LPG system can be seen working, with Do nut tank in the spare wheel well. 114k miles. I heard the strange tapping when it...
  11. C

    Wanted dr650se original wheels offroad

    Want some wheels and tyres sprocket for Dr650se 1999. Currently has supermoto wheels I think they come with 21 front and 18 rear. Cheers.
  12. C

    1996 Bandit 1200 B12 GSF1200

    Sold sold sold Second attempt. Is that Better, not broken any advertising laws? Believe it or not this was my first road bike, passed my bike test in 2011 and bought this. I looked at a few before settling on this one, She was wheeled out of the garage and after checking her out, had to...
  13. C

    1996

    Believe it or not this was my first road bike, passed my bike test in 2011 and bought this. I looked at a few before settling on this one, She was wheeled out of the garage and after checking her out, had to have her. She is in good nick and looks like she has been kept in a garage for most of...
  14. C

    EAS jumped up to high twice in a week Uuuhh.

    Been leaving the old girl for a week or so without using her and I have started to have this little problem (Twice) happened both times about a mile away from home. EAS just goes into high sits there until I push the lock drop her back down. Read a few post and this suggests renew the seals in...
  15. C

    p38 hurricane wheels & tyres x4 on the bay

    I have put my wheels on eBay if anyone want a bid. Located on the wirral for pickup. Few marks age related and curb on one. 3 tyes will need replacing soon. Item number 190746084528 ends on Sunday night 4/11/2012. Range Rover Land Rover Discovery Hurricane Wheels & Tyres With Nuts | eBay
  16. C

    4.6 v8 tapping when hot

    Mates car so asking on his behalf. Changed big ends Changed cam shaft and tappets Inspected rockers bit of wear not much at all Any ideas what else could be causing this, comes and goes too. Checked the manifolds seems to be comming from right side inside somewhere. I suggested a...
  17. C

    96 4.6 Clunk slowing down when autobox shofts from 2nd to first

    Just driven home from work, slowing down once on the estate, change down from 2nd to 1st noticed a clunk. Took it a bit further around the estate only does it some times, and only going down the box from 2nd to 1st. Any ideas? Can't feel any slack in the props etc, can't feel any play in...
  18. C

    Mysterious Oil Weep???????? 4.6

    Right all, this is doing my head in. I have an oil leak which I have traced back to the point on the block where the engine number and dipstick are (just in front). Re-sealed the dipstick, very confident it isn't the source of the leak. Its clean oil too, and not much at all. not enough to...
  19. C

    Found out why I have no r134a

    Connected upto the system ready for a vac out. Put a little bit off gas in to pressure test. POOOOOOOOOOOOOOFFFFFFFFF. Bottom of the condenser. Is it easy enough to change, just thought I would ask, see if anyone has any pointers. Cheers chaps
  20. C

    blend motor or hevac problem?

    Right been at this most of the day. Connected nanocom and got a list of faults through, one of them being the RH blend motor potentiometer, and motor open circuit. So pulled the blend motor off and made sure the blend flap was free, ok. Them opened the blend motor back up. Turned on the...
Back
Top