Search results

Should there be continuity between both ends of plug leads?Silly question but Im getting to the stage where I'm questioning the obvious

My seat base's just sit in the frame and are not fixed,but mine is an ex mod with the fuel tanks under the seats.I think the seats are the same though

Yes, but I never had this problem before,last year no problem,although for various reasons there wasn't much use lat summer,in fact less than 100 miles last year

series 3 exmod,electronic ignition fitted, starts fine from cold and runs sweet,but when I turn it off it wont restart,I suspect fuel evaporation,has anyone had a similar problem and how did you rectify?

Collapsed flexible hose sounds most likely:(

:doh:It was me that asked the same question on lruk forum,But I'd had a few :beer2:and forgot where I'd posted it:doh:

:confused2::confused2:As above,how easy are they to use and more importantly are they any good:confused2::confused2:

Unless some comes up with the right answer,I,d go to an exaust specialist who will match it up with book with part drawings;)

:mil90: What about lifting the slabs,digging a wife size hole,fit said wife in hole and re-fit slabs. Worked for me

:confused:I think there is something not quite right with your tilt,mine has 2 straps per side hanging down on the inside,and to buckles per side on the roof outside to strap the sides up,is yours a new tilt?

What is involved in changing the speedo cable,because mine is knackered aswell:confused:

:welcome2:Hello mark,from a fellow mark

looking to fit an electronic ignition module/pack, to my series 3 2.1/4 petrol. I would like some advice on best kit for the job. thanks