Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. freelandie71

    For Sale Freelander 1 alloys

    I have a full set of freelander 1 alloy wheels. They are in good condition and one alloy has never been used on the road. The tyre size are 195/80/16r, 4 of the wheels have kingpin AT remoulded and the wheel that has never been used has a good year wrangler on it and all wheels have good tread...
  2. freelandie71

    What is this bracket called ?

    That's is the bracket :) thanks guys
  3. freelandie71

    Freelander 1 What's This Lead & Plug Please?

    It is for the fuel burner heater. And I think the plug is store on to the black plastic trim that run from top of rad to metal bumper. I have the same plug but no fbh
  4. freelandie71

    Td5 10p engine question

    I had a 200tdi in the past. Did loads of work on it then the bulk head just seem to rot over night so got rid. Is the Pima engine any better of just as bad. Or is it just safer to go for a 300tdi.
  5. freelandie71

    Td5 10p engine question

    hi all. I am thinking of getting a defender again but a td5 this time. I hear the earlier ones (10p) had problems. What was the problem and is it sortable. Marty
  6. freelandie71

    What have you done to your Freelander today

    Found where my Landy is leaking diesel from. I'd fit the new pump myself but you need a special tool
  7. freelandie71

    Freelander 1 Free chocolate bar for the right answer.

    Hanging a light from when working in the engine bay. If it is the clip I'm thinking of.
  8. freelandie71

    A/ C compressor results.

    Ok I'll do that first, thanks
  9. freelandie71

    A/ C compressor results.

    Video is back.
  10. freelandie71

    A/ C compressor results.

    Seems I did remove it I'll try again
  11. freelandie71

    A/ C compressor results.

    I didn't remove it
  12. freelandie71

    A/ C compressor results.

    Thanks guys. I for got to say there is pressure before I start the landy up. The needle sits between the the 2 red lines on the dial.
  13. freelandie71

    A/ C compressor results.

    http://www.youtube.com/watch?v=B1bD--NJrYI A little video of my a/c pressure reading. The clutch in gauges but as you can see the needle just waves about a bit so do you think the compressor is broken?. The fans don't kick in but then again they would kick in once pressure is up yes?. The a/c...
  14. freelandie71

    Fuel tank cradle change.

    Bugger!! Thanks guys. Think I'll give the job to a garage then.
  15. freelandie71

    Fuel tank cradle change.

    Not want to hijack the "show of hands for a new cradle" thread, to those that have changed it how did you do it. I have had a look and from my point of view the prop shaft and exhaust will have to be dropped. Ok so far but I can't see how you go about getting out the cradle where it goes in...
  16. freelandie71

    What have you done to your Freelander today

    Fitted anti roll bar poly bushes and got to know more of the underside of the car, think I need a new inner drive shaft gaiter, there is a line of grease around the engine bay. Oh and took it to the west of Ireland and back and not one hiccup :)
  17. freelandie71

    What have you done to your Freelander today

    That will be alright, mine went through worse than that and is still on the road.
  18. freelandie71

    Oil change

    I use a pump to do my oil change as now when I take off the oil sump plug im not covered in a jet of hot oil no matter how I go about it and lose the nut into the drain bowl. Only about half a litre is left in the sump after pumping it plus you can use it in the oil filter housing and get even...
  19. freelandie71

    Yokohama Geolander AT-S GO12 your thoughts please

    Should give the lad a round of applause for using the search option [emoji122][emoji122][emoji122]
  20. freelandie71

    What have you done to your Freelander today

    Changed a lower ball joint boot and got it thought the mot, :)
Back
Top