Search results

Hello all. Been a while.. I was very kindly treated to a set of ANR1534’s for my 30th last week. They’ll be going on the 2a as soon as I get the tyres sorted. The truck is on parabolic springs so sits a little higher than standard. It’s currently on lwb rims with 750s. Tricky to photograph but...

Evening all. I’ve come to bleed the clutch up on my series 2a, 1962 2.25 petrol. It’s the early type slave cylinder, and the reservoir is shared with the brakes. All new components, including hoses. Excluding the reservoir and push rod out of the slave cylinder. I’ve bled it conventionally...

Hello there. Hope all is well. As the title states, I’m after a complete loom for my 62 2a (a suffix). I was going to order one from autosparks as they seem to be the go to people. I see I can get one from craddocks, are they ok? I can hold off until they re open but I’d like to be able to get...

Hello there, I hope this finds everyone in good health. While not being able to go to work, I’ve been enjoying lots of time on the landy (1962 2a 88”) I have sat the new chassis down. I have replaced most of the underside of the rear tub, centred and bolted the rear of it up. I have now come...

I acquired my 2a about a month ago. It came from a close family friend. He and his friend have passed the Landy back and forth for the last 12 years. I’ll be putting it on a galvanised chassis. The bulkhead looks ok, though it’s had a few wonky looking repairs. So I plan on stripping it back...

hello there! When I rebuilt my carb couldn’t get the accelerator pump out..I expected it to drop out. Anyway, I put it all back together but I have noticed a load of dead play. Should the spring/piston always be in contact with the leaver? It is only acting on it Having problems with...

hello there! When I rebuilt my carb couldn’t get the accelerator pump out..I expected it to drop out. Anyway, I put it all back together but I have noticed a load of dead play. Should the spring/piston always be in contact with the leaver? It is only acting on it for the last 1/4 of the levers...

hello there, rebuilt my carb. Turned Landy over and she was running fine. Went to the engine pay to see fuel peeing out of this hole. Have I forgotten something or done something daft? Ta, Joe

Hello there. Any help appreciated! ‘62 2a, 2.25 petrol. I have just acquired it, the previous owner told me he thought it had a low compression issue. It has a misfire. Yesterday I thought I’d take a look at it. I went to it cold, having not had it running for a good few days. Took all the...

It appears in becoming a regular here. Changed the box on my d2 td5 manual today. Got it all back in lovely, turn the key...it cranks fine, no start. I THINK I connected everything back up fine, I will double check tomorrow but I'm sure I did. The only thing I can think it may be is the crank...

Td5 manual Splitting the box off my engine..got all the bolts out, starter motor off. All wiring disconnected. Slave cylinder off. Props off..mounts off. It's got about a 10/15cm gap all around but doesn't want to go any further. I am trying to do it on my tod..so can't really watch what it...

Hi. Picked up a d2 on the weekend. I knew there was a possible issue in the box when I got it. But the guy I got it off seems to be sure it's the bias plate or yoke. Symptoms: Slight crunch from 1st into 2nd Slight crunch from 2nd to 3rd Down changing from 4th to 3rd and then to 2nd is next...