Search results

Anyone recommend short term insurance ? thanks

Guys the dreaded fault is back, and its not been raining. Put the heater on it again and it started ok,went out this morning and it wont start again. Is it the BCU if so if I buy a new one what do I have to do to set it all up, I have the Nanocam diagnostic tool. If I get it going again what...

Guys Just an update on the fault, before I started going down removing the BCU unit I thought I would take a chance and put a Electric Heater inside the car, Disconnected Battery Unplugged all the connections on BCU Put electric heater in the footwell pointing up at the unit Left for couple of...

Hi Sierra, just wondering if you can help, I have a flashing B in the odemeter and reading your post looks like the BCU is faulty,if you have any info that you could send me on what to look for or swap, would be helpful any help appreciated Colin

Hi Yes I do :(

guys I have the same problem, what did you do to resolve the problem any help appreciated Taza

2004 Facelift (Manual) Engine wont turn over,everything seems dead Put key in ignition and wont start not cranking, all that happens is i get 6 like audible alarm pings My key fob has not worked for years i just open manually, noticed this time all the other doors don't unlock. Alarm LED on...

Guys as promised After changing the filter housing the car started fine but as the week went on it started to struggle to start, So left it with RWB Warrington, they replaced the ejector seals and now starts first time. So finger fingers crossed Thanks

Just been out and it started first time,will keep you posted how it goes the rest of the week.

There are 4 brass fittings Left rear is ware the recommend black non return valve should - no it’s not been fitted Left front is ware the white air bleed is fitted Right rear is ware the orange duck bill is fitted Right front nothing inside the brass fitting. What I want to know is why fit...

The black valve with the orange duck Bill came with the new air filter housing, so left that one in. So at the moment I have the air bleed valve fitted inside the left front brass connection And the black valve with the orange duck bill valve fitted inside the rear right hand side brass connection

Approx 1pm today it started after a few goes,so still something wrong,I already had bought a genuine complete filter housing so decided to swap it,the unit didn't come with the non return valve so i bought one. The white air bleed valve came with the unit, when I removed the old unit the white...

Guys On Nano no alarms showing, Carried out the bleed cycle and it started,switched engine of and on a few times and started OK ( white smoke) So left it for 2 hours and it started first time,will see how it goes in the morning, This has been going on for a while but gradually got worse, Over...

Yes turns over fine but reluctant to start, once started it runs great, if I stop for a while and the engine is still warm its still reluctant to start. I have the Nano tool is there anything I could check for. Should I be able to hear the fuel pump running in the back of the car ?

Guys Really hard to start, when it does start engine runs fine. Hard to start again even when engine is warm. any help appreciated 2004 Discovery 2 TD5 195k miles

Guys Nano Tool and in the SLABS Yes that was the full error code

Alarm 16-07 Front Left Sensor Output Too Low Intermittent 016 Times Any advice on how to check the sensor before I buy a new one ? Are they easy to remove. Also what does the sensor do ? Thanks

this is the second time that I have had to replace them, must be leaking

Guys If I fit coil springs at the rear do I have do the same at the front ? any guides anywhere ?

Cheers Clutch is OK but the fan is seized, updates to follow