Search results

Hi, I'm using a conversation kit from motor and Diesel Engineering, it comes with the bush you mentioned. What part of the crankshaft do I have to cut? Is there a picture to clarify.

Hey, I'm fitting a Rover 3.9v8 with carbs into my series 3. I will be keeping the lt76 gearbox. Will a 3.9/discovery 1 clutch fit. Is the gear box input spine the same as the 3.9 clutch? And is the clutch it's self to big for the bell housing? Cheers Riley

It's a 109, will probably end up using 3.5 engine bell housing and clutch. Then manufacturer a adaptor plate for the series gearbox, I have a high ratio transfer case that I will be using as well

Thanks, do you know of any kits for sale.

Hi, planning of fitting a 3.5l rover engine into my 76 series 3, is there a conversation kit on the market? And what troubles have been found with this swap. Cheers Riley

Have checked all fuses and relays again. On back of radio only the 2 purple wires have power. Which other ones should ? Is there any fuses on the back of the amp that might affect this? And does the power come from the bcem?

Thanks these will definitely help😀

Hi I have a 2002 rangerover p38. Radio, and heater unit is not working. No power to them. Power is getting through the main fuses and the fuse in back of radio is not blown. Does any one know of any wiring diagrams that could help or any ideas of what my issue could be. Cheers Riley

All engine gear box rubber mounts are new so there should be no movement will check the main shaft but and other bits when I get a bit of free time. Cheers

I have heard lots of overheating issues with electric fans but that may be an option, don't particularly want to cut radiator support just in case of ever converting back to original. Cheers for ideas

Hi, my engine is tired so planning on swapping a blue block Holden 202 in as I already have adapter's. I know that the longer engine does not leave room for factory radiator, does anyone know any options for a radiator without notching the crossmember. 1976 Series 3 109 Cheers

Hi, just thought I'd ask before pulling the box out. Planning on rebuilding my Gearbox it pops out of all gears on engine braking, and I can float gears don't even need clutch. What parts do you think I will need? 1976 series 3 109 Cheers

The current temp gauge does not work, since I am installing a voltmeter and ammeter I decided that I could do the same for the temp gauge.

Hi I am getting some new gauges for my 1976 series 3 and don't know where the oil sensor is (if they have one) and if I need on if i have a water temp gauge . Thanks

Hello I have a 1976 series 3 109 with 11" brakes front and rear. I have got kits for all 4 wheels including springs, shoes and wheel cylinders. I have manged to get all the old stuff off the front passenger side wheel and the new wheel cylinders on but how to you get the new shoes and springs...

Thanks will do

Hi does anyone know what the front and rear brake size is, as I am needing to replace brake shoes. All I know is that the options are 10 and 11 inch. Thanks to anyone who can help.

Thanks will have a look at all mentioned possibility.

Hi, Does any one have an idea why my 1976 series lll 109 does not have any brakes? when I top up the reservoir it drops to a point under the low mark. Where is this brake fluid going? and whats needed to get them to work? Thanks Riley