Search results

Hi, Just as the disco comes to a stop (1-2 mph) the abs pump starts (vibration on pedal) I suspect a sensor or sensor plug. the disco is on tarmac and moving in a straight forward direction. I thought the abs was inhibited from activating under a certain speed. so could it be something else. Thanks

Hi, Back again, in the middle of all the other issues we now have a abs fault. Light came on, but there were no fault codes. Pulled up the live data from all 4 sensors, set away down the road got equal readings from all 4 then we lost communication with the module. Reset the diagnostics and...

Hi, Does anyone know what this is (see photos) Wires are disconnected, pipe goes to vacuum and one to air filter .Thanks

Hi, As part of an ongoing diagnostic I was looking at changing the wastegate actuator, genuine are over £300 if you can find one, cheap ebay about £20-£30, When the cheap one arrived I bench tested it and it cracks off at 3psi and is fully extended at 14 psi. my original one cracks off at 15 psi...

Hi, I have a problem on the Discovery 2 TD5 that it surges when towing a horse trailer up a hill, The wastegate is free easy to move, I checked the actuator using air pressure and it cracks off at 15psi and fully open at 24 psi, The manifold pressure on the hill builds up to 175kPa and the the...

Hi, Just discovered that my D2 (2004) is fitted with a Diff Lock, The lever went across (bit stiff) and the light came on, however it took a bit of effort to to get it to go out. (Diff lock definitely works as I checked by jacking 1 wheel and it locks up) What we didn't realise was during the...

Hi, My td5 engine cranks over but wont fire up, not even trying. Suspected the crank sensor but the engine ecu shows a rpm when cranking so I assume its OK. Rev counter is dead but I picked up on the following in the Rave. The tachometer, which is located to the left of the speedometer in the...

Hi, Sport and Manual lights flashing again, now happening more often, Sometimes a ignition cycle clears them, but now and again it generate a fault code P0705 but it NEVER puts the MIL light on, which it should according to the fault list in the Rave Manual. I'm hoping I can live with it till...

Hi, Using the Lynx Diagnostics its fairly straight forward to switch on the day run lights.You need to have R5 fitted in the cab fuse board. Also there is a link in the R6 slot. The dipped headlights come on full when the engine is running and the auto box is out of Park. How ever the link in R6...