Search results

2004 TD4 FL1 This vehicle is fitted with an air con system and the compressor, switches and relays are all in place. The problem is there is no feed wire or plug to the compressor. It may have been cut and removed at some time and not replaced. All the wiring diagrams I have downloaded show a...

I need to replace the nozzles on the injectors and the part number stamped on them is: DLLA145 P928+ 048731 939 The only ones I can source have the following numbers: DLLA 145 P928 0443172 928 Is the different second number an issue or is it just a batch number? Thanks

I have located what I believe to be the the low fuel pressure switch/sensor (not sure of the correct name) which is fitted under the ECU box. If I disconnect this the engine runs a lot better. Also what is the best way to test this and if it is faulty where do I purchase from? What should the...

Does anyone know what the supply voltage to the solenoid should be? I have tested the red/white wire and get 12.15 volts supply and then tested the brown/white which shows 3.3volts. This is with red probe on wire and black probe to earth on each wire. Reading across both wires is 8.75volts When...

Having found that my Turbo is so badly coked up and the actuator is stuck I am now attempting to remove the Turbo.!! Enough said !! Anyway having discovered that the complete rocker cover and air filter housing also need removing to allow access to the three bolts on the top of the exhaust...

I have a freelander 1 TD4 which starts first time but then runs badly and wont rev more than 1500 rpm until the the temp gauge gets to about half way and then the power comes in and it runs perfectly! Is this a common problem and can anybody point me in the right direction to fix this. Could it...

Have a freelander 1 which starts first time but then runs badly and wont rev more than 1500 rpm until the the temp gauge gets to about half way and then the power comes in and it runs perfectly! Is this a common problem and can anybody point me in the right direction to fix this. Could it be the...

I am having difficulty removing the clutch pedal on my 2002 TD4. I have managed to remove the two lower fixing nuts but it still seems firmly fixed. Is there any other hidden fixing at the top or is the clutch and brake one complete assembly?

Hi all. I purchased a Mk1 2.0 TD4 Auto only a few days ago up to now all is well and I am very pleased with how it drives etc. This is the first 4x4 I have driven and I am surprised just how good the ride and handling is. Having got hold of a workshop manual I have decided to change the auto box...