Search results

Has anyone ever transported a kingsize mattress in the rear of a Freelander 5dr ?

Ahhhhh so thats what that sensor is . :( I have the sensor plugged in but both wired have snapped off . I see the wires but need to purchase a new plug. Car runs fine. Yes there is some smoke but not excessive. I will order one and replace anyhoo. Good post and another problem solved .

I inherited my Td4 from my brother in law. He had the rear brakes cleaned as they were sticking badly. This has lasted about a year and are doing the same again.Is there a full kit available to do the job properly i.e drums shoes and fitting kit or just buy the parts individually? I'm not using...

Typical no instructions at all however straight forward to fit. I will try the two lower mounting bolts to see what adjustment is on them. Ta.

Well after replacing the tailgate regulator and shattering the rear screen a couple of weeks ago I fitted the new screen with the help of an assistant this time. What happened was the window wasnt at the correct angle when going up so it went to the outside of the channel at the top and...

I smashed my rear screen after fitting the new regulator. Everything was going fine until I thought better of asking help to check the glass was running correctly on the way back up. It went up until smash a million little pieces . :) New screen being fitted Friday. At least the demister will...

Mine recently had a similar issue and it was just a hose that had popped off. Cured in two minutes. Do your proper fix on the hose and see how it goes from there.

Happy New year all. Many thanks for all your help in 2017.

Hopefully. I did remove the rear wiper arm and replace as it was catching the paintwork.

Morning. Having a couple of electrical issues with the tailgate electrics. My rear demister has stopped working as has rear wiper. The rear window also wont go down but I think that is coincidence as I can hear the motor working but no movement of glass so that will be the regulator. I have...

The easiest way to do this is to use the 5v kit supplied by Halfords. It has the "add a circuit" inline fuse that simply plugs into a spare slot in the fuse box. No mess and very safe. It comes with the correct 5v convertor also. Very quick and easy to use...

Sorted :oops: Fes up time. So day off and thought i'll have a quick look since last post. I had taken inlet manifold off to clean the years and years of gunk off. I have undertightened the jubilee clip at the top off the hose above the egr delete. It had slid down , hose was still attached...

Thanks for all your replies. Sorry I havent replied at all. I haven't had no time to check yet but will have a quick look today. Yes there is smoke coming from the exhaust noticeably on startup now and when I accelerate hard which there wasnt before. The car was fully serviced with new filters...

Hi guys been busy so not been on in a wee while. My td4 has started to bring on the engine management light.This happens when the throttle is down so far and is happening whilst going uphills or long stretches at higher revs. As soon as I back off the throttle the light goes out after a few...

Has anyone had anymore luck with a kit or fix for the TD4 linkage?

http://www.ebay.co.uk/itm/P99-X91-Steering-Wheel-Stalk-Control-Adaptor-For-LAND-ROVER-Freelander-2003-/182652670746?epid=2077800549&hash=item2a86f2931a:g:sXUAAOSwVJhZXUj8 One of these will allow you to use you steering wheel controls and allow the Sony to plug into the existing wiring...

I will second using that Halfords install kit. It was very good. I also used a small rocker switch with an led as mine was plugged in to a constant feed on the fuse box and mounted it near the steering wheel so it was visible . Just made it noticeable when I was leaving the vehicle to switch it...

Yes. I should have said my cable wasnt broken it was the two plastic cable clips at the ends of the regulator that had snapped. If the cable is snapped you should be able to just manually pull the window down. If you cant do that then just fiddle about with a 10mm ratchet spanner to remove the...

Well today I had the pleasure of replacing one of the two rear window regulators that needed replaced and replacing both rear door glass channel runs and quarter glass. Mine were both badly rusted at the bottom of the verticals. The regulator without motor arrived at under £20 with an alleged...

Yesterday I removed the side steps from my FL1 same as these (these arent mine) http://www.ebay.co.uk/itm/Pair-of-Side-Steps-for-a-Land-Rover-Freelander-1-/172774303460?hash=item283a26a6e4:g:kxgAAOSwg0pZY5M3 . They are in used condition and the brackets will need to be fabricated to refit as...