Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Shrubby69

    Help identifying spare wiring in fuse box. Defender TD5.

    Hi all, quick question, does anyone know what this spare brown connector might be for in my Defender TD5 (2000). It’s in the fuse box in front of the gear lever. I’ve got a basic model TD5 so have a few spare connectors etc on the vehicle (no central locking, no electric windows, no heated...
  2. Shrubby69

    Td5 - exhaust stud torque

    Hi all. Probably a daft question - not my first. I had a snapped exhaust stud - managed to get it out and am replacing them all with longer studs and spacer kit. Manifold skim as well. I believe the studs should be torqued to 25nm (same as the nuts). But as I’m tightening the studs, they seem...
  3. Shrubby69

    Waxoyl - thought it was water resistant!

    Hi all, I recently welded in a repair section on my drivers door and in an attempt to stop it rusting out again quite so quickly I sprayed some waxoyl into the bottom of the door frame. Now, I may have overdone this a little - I put quite a lot in and I was concerned that I might have blocked...
  4. Shrubby69

    Defender TD5 MAF readings

    Hi all. Hope you’re all keeping well. I have a couple of quick questions. I know MAF has been covered loads of times but I’m still not sure if mine is kaput. Using nanocom, at idle it’s reading minimum 63 but closer to 67 most of the time. Which I understand is high - should be 55ish? Flat...
  5. Shrubby69

    Early Defender TD5 Remap Question

    Hi all. There are lots of threads on TD5 remaps etc but I can't find an answer to my specific question anywhere. I am considering having my TD5 remapped - but its a 2000 model so will actually need to be chipped. The new map will be on the new chip. My question is - is the new chip then...
  6. Shrubby69

    New rear halfshaft - now have awful grinding noise!

    Hi fellow forum members. Hoping to pick your respective brains! I’ve just changed the drive flanges all round on my 2000 TD5 90. Front ones all good. Rears are one-piece units with the half shaft. Off-side rear went on fine. Near side rear - seemed to slot in ok. Tightened all bolts up (new)...
  7. Shrubby69

    Heater fan blowing air OUT of wingtop vent

    Hi all, when my heater fan is running (defender TD5) a LOT of air is being blown out of the wingtop vent. I presume this can’t be normal? I must be losing a lot of hot air out of the truck, and presumably letting cold air enter the system? The heater has never been brilliant - thought this...
  8. Shrubby69

    A lake on my roof.

    Hi all, Is this normal. When I rains in end up with a huge amount of water just sat on top of my roof (defender 90). Can't be normal?roof looks like it's sagged - anything I can do to support it from inside? Not sure you can see in the picture. Any advice appreciated!
Back
Top