Search results

Have sused it.. It does start at 0 as suspected , We left the radio on for about 15 minutes and then tried again.. Hey presto it worked. Thanks all Mark

Hi All I am trying to enter the radio code after a battery disconnection , but I have the added problem of no clock/radio display! Could someone please tell me if the display starts at 0 after the first press of preset1 is pressed. I have assumed that it does but I get to the end of the...

Sorry to drag this one up again, But I am still having problems.. I have resolved the fuel pump and replaced the MAF sensor but still the fault light shows on the dash.. The car drives fine. I took it to the local mechanic but the carsoft diagnostic system returned 1612 code and the book says...

bigdanmaddo Have you crossed a post? I'm not familiar with the petrol 1.8 and so am not qualified to answer.. I will look in past posts if you get stuck.. Let me know! regards

Sorry .. I hadn't noticed your request for info.. The bottom fuel line disconnects by pushing in and twisting the connector then pulling it out. I assume by now you have completed your repair.. Sorry again! regards Mark

Hi ming Thanks for your advice.. I tried driving up the road (1/2 Mile) to see if it reset.. I,ll try a bit further and see how it goes.. I'll let you know.. Thanks again Mark

Thanks Ming Nice to know someone knows what they are doing !! I have fitted the new pump .. 10 Minute job again.. Just need to replace the air flow meter now!!!!!!!!! Was told by the garage that the engine warning light that came on at the same time the fuel pump died is the cause of the...

I am about to replace my td4 high pressure fuel pump.(see thread one up from this) I have seen them for 150 + vat + 7 quid delivery.. It was at the famousfour web site Famous Four - Independent Land Rover Parts, Accessories, Sales & Servicing Specialist - Land Rover Parts, Land Rover...

Hi All Again I have just managed to remove the pump with no problem at all.. Looking at the top connection to the filter , it is just a push fit. I used two screw drivers to squeeze the plastic clips in and prised the connector off. The bottom connection to the multi way connection block was a...

Hi All Can anyone tell me please how to replace the high pressure fuel pump in the front engine bay of a 2000 TD4. I have removed the small philips screw from the housing and un hooked the casing from the side. I'm now looking at the fuel hoses and thinking Umm , Does this need specialist tools...