Search results

Cheers guys.I took your knowledgeable advice and cut it off.Used a diamond tip disc but still took a bit of time.Drove home from high Wycombe....no difference.Thanks again.

Nodge to the rescue again.I am assuming the front part of the prop can be taken down separately from the back or does the whole lot need to come down?

Afternoon all. The propshaft torsional damper on the wifes freelander (did I say free...should be f..ing expensive) has separated with the outer metal ring banging around.The Inner rubber ring looks worn.Can I replace this unit or do I need anything else.If I can replace it,how easy is it...

Cheers Nodge.Would you know what the black box is that is located under the fuse box and is bolted to the inner wing.Looks like it has pipes going in and out(one going to the fuel injection bar (I think that is what it is))Could that be intermittently failing? Really appreciate all your help.

Evening all.I have an intermittent problem with my wifes 03 freelander 1.8 petrol starting.Think I have located problem as when the pump whirrs when turning on the ignition she starts (car not wife) and when the pump doesnt whirr she doesn't start (car) but wife does.Am going to replace (fuel...

Ok.Only two bolts holding motor in.Undid those, slipped out the motor, put new motor in,bolted it up,replaced big red wire,replaced little wire on solenoid,refitted air box,secured battery,put key in ignition,gave it a turn and.............bingo.Easiest job in the world if you have the right...

I thanks for that. do I need to move the bar above the starter. I can only feel/ see two bolts.

No I haven't got RAVE.What is it .Feel like I'm going raving mad though.

Morning all. Tried a direct feed to the small terminal on the solenoid. Nothing at all. Am assuming now it is solenoid defect. Have started to remove starter and solenoid but can't seem to find starter bolts. Have undone the two long bolts (5-6 inch).Where do I find the main bolts to remove the...

No nodge. not tried that. is it the little wire at goes on the spade terminal

Thanks neilly. I will try if need to remove motor. Hoping it won't be necessary.

Afternoon all. As a follow on from my last post, can you bench test a starter.

Afternoon all. I ask this question before I start to take out starter from my wife's 2003 1.8 petrol freelander. All was fine with it and then total failure. Does this sound usual or have we got some more freelander gremlins? All answers appreciated. Thanks

cheers all. Alibro I am laughing like a drain.Brill Avatar

thanks.How easy is it to replace

Evening all.Not sure if this is the right site so have also posted on the engine site. Following the success of your last replies to my post I have found another fault (at least I think it is). The engine is a 1.8 petrol K series in 2003 freelander (I know I know) but the good lady bought it...

Evening all.Following the success of your last replies to my post I have found another fault (at least I think it is). The engine is a 1.8 petrol K series in 2003 freelander (I know I know) but the good lady bought it before I could research it and now I am having to sort it out. My question is...

Sorry Joe H.Meant to congrat you but you know that.

Just had AA round and dreaded slave cylinder has blown apart.(why is it made of plastic??) Needs a new mounting bracket as well.Getting recovered to local garage (friendly honest one) to get the job done.Looked like I could have done it but needed to get it done quickly as going on holiday...

THx for the reply Lowbank.Should have said its a 1.8 petrol freelander 1 on a 2003 plate...(everything you shouldn't buy i have since found out).