Search results

Thanks very much for your reply, I have had a look at your pages and they appear very helpfull. I'm sure that I'll find the answers to my problems in there somewhere. Many Thanks Iain

Thanks, I'll get my meter this weekend and start probeing deeper

I have an 1989 3.5 efi RRC with a flapper AFM. If I take all 8 plugs out and wire brush them clean, it starts on literally the first crank of the engine, and will run for about 1 -2 minutes then cough and splutter and then dies. I can get it to start again after cranking it over a bit, but it'll...

Thanks, I have the 'P' clips still, I will have a look again tomorrow bearing that in mind, the fact that I'm trying to find a hole that isn't there may explain why I can get them to work. Thanks for the clues, fingers crossed I'll get some tension on them tomorrow.

I have replaced my rear crossmember a few months ago now, and am just now getting round to putting it all back together, but I cannot fathom out how the tension springs for the lower tailgate hinges go into place, I've figured that they obviously have to have a twist in them in order to apply...

I know that there is only a small difference between each side but now that I've spotted it I notice it all the time. Just to confirm, the gap difference that I've measured is from the top of the tyre to the wheelarch.:confused:

I posted a topic back in Jan regarding my disco's ride height. The Drivers side at the front sits about half an inch lower than the left. Last weekend I changed all four springs with new springs c/o britpart, and it has new shocks all round already, however it is still sitting low on the...

Hi I have a 95 ES V8 and the front drivers side suspension is sitting about half an inch (13mm) lower than the left hand side, I have jacked it up on the chassis to let it the spring hang to inspect it and it all seems fine, Is it possible that maybe the previous owner was a bit of a bloater and...

That's great, its is definatley gurgling, any tips of how to bleed the air out, it has recentley had a new water pump, prior to my ownership, so that could account for the air in the system.

Hi I have a 95 V8 disco which when I go up or down any steep gradiates I experiance the sounds of water gushing around somewhere, sounds like its right behind the dash, but it would do if I'm driving. The carpets are dry and there is no obvious leaking internally, Just wondered if anyone has any...

Yeah I agree, the magnacor leads are definatley worth the money, with a Lucas dizzy cap and arm, its all running very smooth, all as should be.

Thanks, I've got it running on NGK's and magnacor HT's and a Lucas dizzy cap, i just want to make sure that I get the timing spot on as I know that it can make all the difference.

I have a 3.9i Disco on LPG and have been trying without much success to find what would be the optimum timing for it to be set at. I realise that LPG likes a lot of advance compared to the 5 deg BTDC for Petrol, but as I start it on petrol until it has properly warmed up then switch across to...

Thanks, will try the sender, its been driving me mad.

I have an 89 classic 3.5 efi on a flapper, which is an ongoing restoration project, (lot of welding to do), which will run for about 20 minutes idling lovely and then you touch the gas and it cuts out and won't restart. Removing the plugs shows that they are wet with fuel. If I clean them all...