Search results

Had it checked by a local LR non dealer garage. All good. Can happen with non LR parts its seems.

That's interesting as it seems to have started since i changed the front disks and pads. I wonder what is different ?

Any ideas on this one. Freelander 2 Manual 2011. If i use reverse and then move away in 1st gear on the first use of the brakes after that i get a clunk from the front of the car. Only once . does not happen again until i do the reverse and move away sequence .

Thank you

Hello All I have read in several places that a free service manual exists for the Freelander 2. All i seem to find is links and sites where you have to pay. Is there a free official Land Rover one for the FL2? Thanks in advance

1998 FL1 1.8..91K and going strong.

Agreed I believe there is a small 2 maybe 3 BHP increase, minor really but the drivability is so much better. It's a very free raving engine anyway and its even more so now. :-)

Hello All Its been a while but still enjoying my Freelander :) So i was getting a strange drop in revs when coming to a halt after a long run. It would almost stall but recover. Bit of research suggest on old Freelanders like mine (1998) they plastic throttle bodies can cause problems when...

I meant to get back on this. Took the exhaust manifold off in the end which luckily was not problem. The sensor was really tight , in the end i had to heat up with a blow torch to loosen. New one fitted , new head studs and nuts for the manifold and all good. Thanks Struan

Hi all. Why is this lambda sensor in such and impossible location? Is the only way to remove it to remove the exhaust manifold.. Any trick ways of getting it out appreciated .

Not for the inertia switch. Its only held with a couple of M6 (i think) nuts. But you start working around the fuel pump then yes you should disconnect the battery!..

I actually unbolted mine from the bulkhead and gave it a shake and then reset. Might be worth 5 minutes to try. But looking at your pictures i'd also check those wiring connections are good!

Be worth checking that the inertia fuel cut off switch has not gone active. I had this on mine last week for no reason. Took it off gave it a shake and reset buy pressing the top and bingo fuel and started. Mines a 1999 1.8 petrol to. The inertia switch is under the bonnet on the right hand side...

I was looking at fuel pumps a how to change etc. I think mine is not well... Any way took the inspection plate off to take a look . What surprised me was that even thought the pump has two of the fuel pipe connectors only one of them had a pipe connected and the other was blanked off. Everything...

Many thanks GrumpGel. All installed and working!

Ok can anyone tell me where the CRANK position sensor is? Is it the one down below the start motor on the left had side of the engine (looking from the front)

I will take some and add them to this thread over the weekend.

Engine is 1.8 petrol K series R Reg 1997/8 ~(yes i know but it was free lol ) Being MEMS 1.9 explains no CPS then. I can remove that from the possible causes. New inertia switch will be fitted tomorrow. I assume by ignition switch you mean the large plastic multi pin unit on the end of the...

Hello All I had the Freelander cut out on me a couple of times recently. Suspect the Inertia switch or crank sensor after reading the forums. New Inertia switch is on order . As for the crank sensor it looks like the one on mine is a a dummy and just a blanking connector in the bell housing...

Just an update on this. Upgrade completed without any real issues. Temperature gauge now seems much more stable and not move about like before so all good.