Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. D

    TD5 Wiring Loom

    Thanks for the reply and that's good news, if I do need to go down the route of a wiring harness it will keep it a bit simpler for me. I'm not great with electrics. Sorry not to have given a fuller explain: I changed the injector harness a few months ago, there was only minimal oil seeping...
  2. D

    TD5 Wiring Loom

    Hi All, apologies if the following has already been covered. My car is D2, TD5, 2002. I have 3 electrical problems; 1. No voltage to MAF sensor. 2. Air Con clutch not engaging. 3. Glow Plug relay fault; no power to plugs. I've hot wired MAF sensor and air con when needed and can live with...
  3. D

    300tdi Engine for manual or auto?

    Not even had a look at it yet mate, if I do it won't be till next week sometime, if it all works out I'll message you. Enjoy the games :)
  4. D

    300tdi Engine for manual or auto?

    Thanks mate, that's great, I thought it should be but wanted to be sure, cheers
  5. D

    300tdi Engine for manual or auto?

    Apologies if this is a stupid question, also, I can't find it on FAQ's. My 300tdi manual engine needs to come out, it's leaking oil, smoking and generally rough. Just done a 1500 mile trip with a caravan and it's at 200,000 miles so it's a bit tired. Anyway, question is this; can I put a...
  6. D

    Newbie, brake disc issues

    Sorted! Got to come clean, I was doing something stupid, I had the rear guard in the wrong position which put the caliper at an angle. Thanks for the advice everyone, it made me stop and go over everything till it made sense. One piston has seized and now I know it's all standard I may as...
  7. D

    Newbie, brake disc issues

    forgot to say, I dismantled the hub and disc and re-positioned it but still fouling
  8. D

    Newbie, brake disc issues

    Thanks for the replies, I did everything by the book, cleaned hub and bedded in okay, torqued correctly, new bearings etc... end float checked. Pads are held in by split pins. I can just about squeeze a pad in on one side but the width is actually smaller on the other side so the disc is not...
  9. D

    Newbie, brake disc issues

    Hi Everyone, restoring my disco 300 tdi, 1994. To take a break from cutting, grinding and welding, I thought I'd replace rear brake discs which are quite worn. I bought the discs over a year ago part no. FTC 461 now superceeded by FTC 1381. These should fit all discovery but seem to be too...
Back
Top