Search results

Ok so iv just picked up some new bushes for my rear watts linkage and arms Just a quick question and I apologise if this is stupid in advance which I think it may be but have to ask Once removed are you able to drive a disco 2 without the watts linkage fitted? Reason being is I have to...

Shall get under it tomorrow and have a gander :)

Drop link! ? Just changed over the ace to the standard anti roll bar so I'd like to think these are all good... Watts linkage... Would this knock when rolling the body? That had not crossed my mind

Ok so I know this has been asked and if read up on possible trimming etc But if managed to find a great deal on a set of near new bf good rich mud terrains 235/85/16 for my disco 2... I'm currently running 235/75/16 AT BF GOODRIDGE On modular steels buts they just don't do what I need. My...

Developed a new fault this week :) when turning left there is a knocking coming from the drivers side rear corner... When outside the stood still and rocking body the knocking occurs from what seems to be the suspension Shock gone? Any ideas before I buy a replacement part? Cheers

So I've found a oil leak after seeing a puddle on the floor yet again this morning.... Gotta love these land rovers I changed the water pump last week and in the process I had to remove the rotor filter bracket..... Now it looks like it's leaking from the two rear bolts.... I can't say for...

To be honest I removed mine last week following a drastic leak. Not noticed a massive difference at all in the handling been around a round about 30/35pmh and doesn't really tilt much more than before and can still get the back end out without feeling like it's going to tip over.... The above...

I have ordered a new expansion cap today. This may sound daft but As I'm fairly competent at mechanics and fixing things just new Landy not familiar with the td5. Where can I locate the water pump? And where abouts is this blanking plug ? Thanks

Ok so Iv got an issue with my td5 on 103k It is using a little amount off coolant currently topping it up after a two week period and 350/500 miles not a huge amount maybe 10-15mm I have no apparent leaks as checked all over and pressure tested the cooling system which I pressured upto...

Can a td5 run on veg oil ? I'm very interested if it can be? What's the best mix for this? May consider bio aswell and purchasing a producer as I'm sure it would pay for itself in quite a short period of time? :)

Bit the bullet and removed all the ace today new parts being delivered tomorrow!!!

May just replace it's all with anti roll bars price if the removal kit is not a great deal more than the pipes axons bits needed to fix the problem and then the hours involved with this... I'm fairly competent with cars.... Big obj removing the ace system? Evening work in the garage or a full day?

Is there anyway I can use it until the weekend and disarm the system IE fuse or unplugging some of the connections? Thanks

Any how to guides that you know of guys? I have the light on the dash now . Is it ok to drive around with this on as its my daily Veichle ? Is it better just removing the ace system altogether ? It then gets costly

Ok so been out on a pay and play today ended up loosing my ACE pipe. It's split where it folds over to top of the rear ACE AND and then runs over the chassis down towards the block Looks like it been wedged between the axle and the ace ram/u it itself..... How can I go about sorting this...

So birthday earlier this week and was a good excuse to take the day of work to spend some time on the Landy. Fitted the snorkel to start the day off. Went quite smoothly and very happy with end result Then changed all the oils in the front and rear axles, transfer box and gear...

As the title says realt developed a slight clunking sound when pulling of and when going over some in even ground in low box. Also have a humming sound between 1000-1300rpm from engine area it sounds like the power steering ? Any ideas guys would like to sort soon m Cheers

Ok so I'm planning on kitting my td5 out for a little wading now and again Can anyone advise what kits are available for the breathers? I'd like to buy a lot for the diffs and transfer box all in one ... Can anyone recommend or give me a link? I have read that the ecu needs to be moved ...

All fixed was full of dirt and hair cleaned them all out now windows and seats heat up like they should. Cheers

Thank you for that will pull apart tonight and let you know how I get on Thanks