Search results

installed new rotors, carriers & pads after finally (after at least a year) diagnosing a noisy off-side front brake. Seized guide pin for the win. Inner pad, rotor & carrier were toast. Been living with a seized clutch release fork for about 2 years - savings in petrol over the past few months...

disconnecting the coolant temperature sensor causes the radiator fan to run continuously - it is likely that the sensor has failed or broken/corroded wires or connectors. cheers, Simon

clutch release lever was seized - angle grinder said hello to 27mm impact socket to cut out 2 adjacent faces - socket & breaker bar made short work of freeing up the shaft from the bell housing. Plenty of Plusgas, obvously. 20 mins of working it back and forth got it properly freed up. Clutch...

thank you - one less part to worry about. Cheers mate

the one in the bell housing where the rod goes in mate

wont get a chance to do any work on it till saturday - a big hammer will be the first tool out of the box but I'm getting ready to do a clutch replacement anyways so ...

so I have the slipping clutch issue & obviously need to pull the gear box & unseize the clutch actuating lever - but since I will need a new seal & can't find the part online I need the info - part number or a pointer at a site where I can get the seal. Anyone help me out (casting furtive...

pulled the prop shafts & vcu, prompted by a metalic rattle from under the car when moving and a repetative thumping from the rear left in low speed corners or at low speed decelerating to a stop in gear. Took it for a drive after removing the the props and vcu - all the noises are gone away. So...

well, the MIL likes to light up every now and then and the code it calls is cat not running at full efficiency so I did kind of know. I just clear the code and keep on truckin but I think you're right that it will need to be replaced by next April Cheers Simon

spent 3 hours on wednesday night in the pouring rain wrestling off the old track rod ends and fitting the new ones - took it for an alignment yesterday - took it for mot today. It only f-in passed! emissions were over so the tester rev'd the nuts off it till it came within spec, bless him. It...

found out why my tyres are foobar - knackered track rod end - it just never ends. mot on friday - picking up the part tomorrow - we'll see

last post to this thread: if you look hard enough you can find free downloads of testbook - clicking on that link will give your confuser a VERY BAD EXPERIENCE - no need to ask how I know :oops: An earlier post to this thread by the legend that is Nodge called out for anyone in the Stevenage...

I am happy to report that a 1.5 Ohm resistor is the golden ticket! aSRSe light is OUT and I am a very happy bunny :) Machine don't win - people win Cheers Simon

fixed it! went to the garage and had them pull out the dent as much as they could - they used a chain round the spare wheel bracket and fixed the othe end to an I-beam concreted into the ground and drove away till the dent pulled out while I stood and winced. Window still didn't want to retract...

I shall be calling it the ars(e) module from now on due to it's being such a pain in the backside ;) Cheers Simon

Original fault couldn't be diagnosed coz Autologic could not connect to the srs module - I replaced it with a 2nd hand unit. Now Autologic can talk to the srs module and it calls a fault code saying high resistance on passenger airbag - but there is no passenger airbag & never has been. So the...

I found the connection into the loom (it was very well hidden) but thanks for the link ;) Cheers Simon

I hear that mate - but since I'm struggling to find the connection into the loom on the passenger side neither option is viable at the minute :( Cheers Simon

took it to the garage - now the autologic scanner can see the srs module - but the srs module thinks there should be a passenger airbag so it still calls a fault. There is no passenger airbag from new. So if there is a connection on the loom for the passenger airbag I can fit one or trick the...

put a replacement srs module in - put the facia, centre console, steering wheel and drivers seat. then noticed that disconnecting the battery had caused a fault on the tailgate window - someone put a dent in the tailgate a few months ago & since then the window wont fully retract - now after...