Search results

Hi mate where are you based? Thanks

Hi driving today and the clutch has completely failed, so am doing to replace it almond with the release fork and slave cylinder just to be on the safe side, What would you guys recommend for brand of clutch? Was thinking of a britpart clutch but as the rest of there products seem poor I'm...

Replaced the switch and all sorted thanks!

Just put new thermostat and pump in so she's should be Good possibly a blocked rad and a oil pressure switch hopefully :)

Hello My 300tdi oil light comes on, when you rev slightly when engine is cold the oil light will go off but when the engine is warm the light will just stay on, also the water temp guage gets hot, near red when sitting at high speed 60 mph was thinking possible head gasket? What are your...

Ok thanks :)

Hi Does anybody no how to replace the door lock barrels on my series 3? Thanks

Hi all I'm considering on selling my landrover It's a series3 109 hybrid (pick up) Custom galvanised coil sprung chassis built by designa chassis 300tdi running gear General tidy enough condition for a old landy Obviously I haven't seen many for sale like this to compare with so...

Will try get some pics up asap

They like they have been made like this and not tampered on any way

Hi I have a hybrid 109 series 3 and I'm really struggling to find a replacement bump stop, I currently have bump stops that only have 1 hole that goes right through the middle of the chassis (through the side), and the only stops I can't find for a series or a defender etc have various holes...

Hi all does anybody no the coolant hose Id diameters for the heater matrix and the radiator over flow ( really small hoses) for a 300tdi defender? I would go and measure them myself but the truck is 75miles away from me ATM Thanks in advance

Hi all looking to fit an electric fan to my 300tdi defender rather than a viscous but not really wanting to pay top money for a kenlowe etc, just wondered if any of you guys have used a fan off another car like a 306 or something easily found? If so what fan? Thanks

Thanks a lot lads

Thanks you sir! Lovely fast response

Got a core plug that's rusty and leaking, how hard are these to replace and if so best way of fitting the new plugs, I'm going to replace all 6 as they all look abit corroded, Thanks

Hi all in the process of relocating my fuel filter to the bulkhead as the previous owner left it just hanging in the engine bay after the conversion :mad: soo I need some new fuel pipe as it's way too short ATM to do anything with. Anybody no what diameter pipe I will need from the fuel filter...

Hi mate any pics and where you located? Cheers

Ok thanks a lot guys,

Lovely that's just the answer I was after! Thanks a lot :)