Search results

As per title, need the glass and rubber surround...

Mine has gone brittle, and now my exhaust is on the body :(, I cannot seem to find a stockist anybody know where to get hold of the rubber that holds the exhaust in the hole..

So having got all my starting issues fixed, the last couple of days on starting it sounds like a bag of nails/rough until i give a couple of stamps on the accelerator then all is great, is this normal for a 3.5 V8 running carbs or does it point to an issue, i am thinking maybe the carbs are...

So what i thought would be nice and easy ;(. I have brought a new momo steering wheel, thought i would do the right thing and count the splines on mine to see which boss i need. Currently i have some cheap aftermarket momo copy, so took the wheel and nut off but cannot move the hub, should...

Hi All, Strange one, the steering on my 90 does not return to center after turning, i.e i have to take the amount of steering off after turning a corner.. Anything i can check before dropping her down at the garage? cheers Mark

So following on my quest with my V8, I would like to convert to EFI, but garages are not keen (i do have a kind offer of help from marccleave but he has a lot on his hands with his own project ;) ), a new edlebrock carb with auto choke might solve my wife not driving issue.. Anyone done this...

Thought i would punt again to see if anyone can do this for me (tried my local places and none have the skills)...

anybody know how they work, i have tighten the nut up behind and sometimes it says out other-times its does not... On a related note if i start the engine (3.5 v8 on Strombergs), and the choke goes back in the car dies and then is really hard to start again, any ideas why this would be?? thx

Guys, Anyone got any picture of how to setup this on twin strombergs, i have a new dizzy from simonbbc.. thx

So having replace the distributer and ignition coil, i thought everything would be rosy however its not... Got a very strange problem, sometimes the car when warm starts almost before you have turned the key, then other times it really lazy and takes forever before turning really fast and...

Hi folks, Is there a special tool to manually turn the engine to get it to TDC? I also cannot see any markings on the wheel,any tips? Hoping not to have to use the old stick down number spark.. cheers

By chance a mate has a 4.6 V8 from a Range Rover, I was looking todo some upgrades to my 3.5 V8 on carbs, but it might be better just to swap the whole engine out for a much more powerful unit. Anyone got a ball-park figure for what i would get charged to-do this??? cheers

Taken from a 2010 Puma i was told, wanted to fit them to my 90, but given i have an old one it means i have to cut the wheel arches which i don't want todo, they go for over 500 on ebay was looking for £450..

My 3.5 V8 90 is currently at an indie having a few jobs done, one was to check the poor starting, they have said its down on compression (which would explain why i have been looking to get more power out of it :)), they mentioned it could be the cam shaft (lobs was also mentioned), but they are...

Looking to swap out for a quad, let me know if anyone has one they want to sell :)

Hi folks, Anybody got any good contacts who would setup and then fine tune my V8?? Cheers

Hi Folks, What would you expect to pay for the below work at a indie? Replace both front pinion seals,Rear drive shaft seal and thermostat housing gasket Its a 3.5 V8 90 cheers...

Hi All, Got a dripping of fuel out of the pipe that attaches to carb as per below, i have tried to tighten but makes no difference, do i need a replacement pipe or is there some magic way to adjust ;)

Harder to turn, and a funny honking noise when going from lock to lock?? Any guides on how to replace... cheers

So thought this would be easy always replaced my own pads and discs, but all the part numbers have been superceeded, prices range from 9.00-60.00!! Any recommendation for which parts I need and from where??? Cheers all