Search results

Hi All When out today and very, very occasionally the brakes went hard and it felt like the ABS went on but not allowing much pressure to be applied and therefore not stopping very well. When lifting off the pedal, and reapplying the brakes sometimes worked without the issue coming back and...

Hope someone can help, I have replaced the swivel on my ABS disco 1 and in the kit was the thrust washer FTC 124 and when reviewing the manuals, Rave and youtube videos there is no mention of this, just the fitting of the upper swivel mounting thrust washers and needle rollers. If I fit it...

Looking for advise.. I am wanting to install air lockers (probably ashcroft) but as they are so expensive I wonder if I can do them in stages i.e. front first and later on rears or just do one and not bother with the other. If only one, which diff is best to focus on? Thoughts welcome please. Thanks

Folks have fitted a new seal and flange kit to disco 1 but when I tighten the flange retainer bolt (not the nut type) to the 72nm if pretty much locks up and wont spin by hand but will at a push if i put socket on the nut to turn it. Fitting the halfshafts to see if the flange spins when they...

I want to get rid of the rubber donut on my 300tdi disco and wondered if there are any 200 rear props about from people breaking the 200? Posted please to Nottingham. Thanks

Folks I went to Yarwell yesterday and did some wading (above the axle, I have extended breathers) and when I got home I noticed a substantial amount of diff oil dripping on the floor below the axle. When I looked further it was all over axle case and the rear of the chassis to the point of...

Hello all, I need to replace the rotten N/S inner wing on my S Reg disco 1 and ideally want to remove the ABS module for easy access. I will label the pipes and fittings accordingly but want to ensure that just fitting and then bleeding the brakes is a straight forward process as I have read...

Unfortunately I have 2 broken bolts in my rear hub for the halfshaft retainer flange and they aren't coming out at all so I am after a second hand hub. Its the ABS type so must have the holes for the ABS plate. Hopefully someone breaking one on Landyzone can supply.. I am in...