Search results

Hi All Can anyone help me out by recommending the best tool to replace upper and lower swivel ball joint that does not cost an arm and leg and that actually works much appreciated to all

Thanks Stanleysteamer much appreciated comment

Hi all dreaded m+s lights with D flashing on display and also red lights on gear shift I could only get 3rd N R and P Plugged in Nanocom fault was P0743 solenoid valve lockup clutch monitor (s/c to ground or o/c) nanocom's are fantastic!!!! pointed me in the right direction.Any way looked thru...

Hi backinblack thanks for your input managed to get a second hand pedal fitted it today on the off chance all probs sorted running like a dream kind regards davethebuilder

Thanks ronsealdeath managed to get a second hand one today all good running great

Hi every one does anybody know if I can buy a throttle position sensor on its own without the peddle it needs to be a 3 position type for a discovery 2 reg GL53NLJ and if so what is the part No and where from. I'm asking this because at about 2000 revs steady on flat engine dies m+s lights on...

Much appreciated thanks tilly2

Thanks Hippo

Hi everyone I have a motor weir noise in nearside headlight when headlights are switched on is there a fix for this or do I have to replace complete headlight many thanks Happy New year

Thanks brianp38dse hopefully i will find my answer here

Hi everyone I have a motor weir noise in nearside headlight when headlights are switched on is there a fix for this or do I have to replace complete headlight many thanks Happy New year

Thanks eightinavee I will check out if it is overboost problems before any adaptive reset thank you for your reply and info much appreciated Kind regards Dave the builder

Thanks Shifty Have changed gearbox oil and filters and rechecked levels all OK haven't reset adaptive values to gear box yet (too scared!) but if I do I will just drive it normally thanks for the information Regards Dave the builder

Thanks Wammers Will go to gearbox on Nanocom Press Utility, press reset adaptive values.And then drive it as normal Kind regards Dave the builder

Thank you Sierrafery I couldn't find any answers anywhere else so didn't know what to do. Just to let you know I have a problem when I put my foot to the floor the auto-box changes up and down then up and down like kangerewing normal driving is fine and nice and smooth I asked nanocom about this...

Hi everyone Can you help? What do I do after resetting adaptive gearbox settings. Do I drive it as gently as I can or do I have to drive it in all gears ie 1st 2nd 3rd and drive or do I cruise it down motorway or drive it hard using kick down ect can anyone help? Kind Regards Dave the Builder

Thanks for your reply again. The oil was very clean so I'm hoping for no mechanical faults (fingers crossed ) I'll change the box oil a few times over a short period and see if it helps kind regards Dave the builder

Wow that was quick! Thanks for your reply James I did an oil change about a month ago plus filters as per book maybe the oil is a little low I will check it during the week you don't think its kick down adjustment if there is such a thing? sorry if this is a dumb question but I'm new to disco2's

Hello to all I'm new to this site and thought I should become a member as this sight with all your help has been a great help to me. I have a disco 2 td5 2003 plate which has a problem with autobox all seems fine in normal driving gears change smooth ect but when I floor it acceleration is fine...