Search results

Looking for a 19j injection pump to get my series 3 project finished. Must be a good pump. E-mail me if you can help. Will consider a complete engine as a donor if necessary. I'm in Suffolk. [email protected]

Thanks for the reply, I was hoping that I wouldn't need to remove the skin. But just below the window. There is a plate that seems to support the outer lower window seal. This has rusted away at one end and it is hanging down and the seal has gone with it. Does the door skin wrap round the...

Hello. I've taken my Defender off the road for a proper sort out. I took the drivers door off today. Stripped it down to find that it's in a pretty poor state. Has anyone repaired one-piece doors? I need to take this skin off to repair the frame. Anyone know how easy it will be? All advice...

You have a PM hughesy. Thanks.

As far as I can see, the oil seal must separate the oil in the axle casing from the grease in the wheel bearing void. Did the type without the seal have some other form of seal? or was the oil allowed to mix with the grease. I've got tax on the truck til month end so I need to find the shafts...

hi, i've just bought a 1992 discovery which had no drive. The rear diff had died, and it took the halfshafts with it. Problem i've got is, i can find loads of 10 spline halfshafts on ebay, but my ones have a raised and machine section about 4" from the drive flanges. does anyone know if I can...

Hi I'm not a breaker, but I have broken land rovers in the past when they get a bit moth eaten, I still have A few parts kicking around and i'm always getting offered odds and sods, i'm in a village just north of ipswich http://www.freewebs.com/roverengineered/ most of my parts are on there...

i'm going back to series diffs because, i want it as a towing/ off road land rover i will never do any mileage in it. so i want the original ratios. sam

I've got a swb series 3, the previous owner has put RR diffs in it, what is envolved in taking the RR diffs out, and going back to series diffs? do you have to do anything clever? "my brain doesn't enjoy working at weekends!" Are there any shims or washers that are likely to make a bid for...

hi, i have been offered a land rover 109" one ton, it has the 2.6 petrol, low ratio box with hydraulic pump. good chassis, good bulkhead, good body. It is open for offers, i've been looking for a 0ne ton 109" or a foward control for towing and heavy work. i don't really know what to offer...

Hello, I have constructed my own web site, it is still under construction but the for sale page is up and running, if anyone wishes to put an advert up on there, just e-mail me, and i'll upload it. http://www.freewebs.com/roverengineered/index.htm I also have some bits on ebay at the moment...

Thanks for your advice guys, i had'nt given much thought to the brakes, which was a slightly bad idea! Would it be possible to fit defender axles? modify the chassis to recieve coil springs as well? this would help with both braking and supension, if it is possible, any thoughts? Which...

I have two LWB series landrovers, I am putting the series 2 body on the series 3 chassis and sticking a v8 in it, and using it for offroading. i have been out this morning and collected a carbed 3.5 V8 engine with a series coversion plate, but i have been told it is missing a spacer that fits...

I have two LWB series landrovers, I am putting the series 2 body on the series 3 chassis and sticking a v8 in it, and using it for offroading. i have been out this morning and collected a carbed 3.5 V8 engine with a series coversion plate, but i have been told it is missing a spacer that fits...